Now I moved on to installing the Johnson pumps. There are many places to install your pumps and all of them have their advantages. I just chose to install mine in these places to make my life easier. It’s best to look around on the forums and see what others have done, then get in your boat with one of the pumps and try holding it up in a few places.


First I removed the carpeted panel under the rear seat cushion and above the bilge access to expose the fiberglass wall. If you don’t have this carpeted panel not to worry you won’t be able to see the screw holes anyway when the rear set is back in place.



Hold up the pump on the outside to mark your screw holes. I held the top of the motor flush with the bottom of the backrest off the seat. It is slightly toward the center to avoid being to close to my fuel intake lines.