Putting T Handle in LSV. How do I remove the floor?

[08LSV]

how close is the second hole to being over the flat spot? could i mod the tank?

Not even close from what I could tell, the flat spot is in the middle of the tank between the two holes from the measurements I took... Your on your own with the tank mod, that is one bear I wouldn't poke with a stick if you paid me...

Yeah what about the hole in the center of the tank? I know that the hoses go there but could possibly put something there to keep the hoses to the side of the hole to reach the T-handle.

The problem with the other hole is that from what I remember it is directly over one of the tracking fins.... I am heading back over to do some ballast work on it tomorrow so I can spend some more time than I had the other day to double check my measurements.

I picked up a 2" brass drain from west marine earlier just to see if it will fit the flat spot under the hull. May not be convenient but at least it will be there if I need it. Anybody have any other ideas before I start drilling?