Results 1 to 10 of 27
-
08-09-2011, 12:52 PM #1
Where is your dripless Shaft Seal cooling water T'd in?
Curious as to where everyones driplessis T'd in? Mine was off my exhaust quick connect. It started leaking again so I T'd into the thermostat housing to rear cat exhaust dump hose as this line stays cool and was easiest. There was not enough clearance between tranny cooler drain and alternator to come off there. So far the dripless is dripless as the vesconite housing is not expanding due to hot exhaust water
09 21v LAUNCH
99 Outback LS. Sold
run your engine after you change your oil
68 th Member. WS420,HSE Revolution, OJ 466, Acme1157,1100 sacs,Kicker HLCD's n IX500.4, Supra Coolies
Doug
-
08-09-2011, 01:11 PM #2
Hmmm i'll have to check mine. Season four now without issue but it sure won't hurt to look either. Thanks
2007 Mobius LSV
-
08-29-2011, 05:23 PM #3
Anyone here?
09 21v LAUNCH
99 Outback LS. Sold
run your engine after you change your oil
68 th Member. WS420,HSE Revolution, OJ 466, Acme1157,1100 sacs,Kicker HLCD's n IX500.4, Supra Coolies
Doug
-
08-29-2011, 06:00 PM #4
On my '10 LSV it is coming from the drain plug of the transmission cooler.
2014 Mojo Surf
2013 Mojo Sold
2010 LSV Sold
2002 OB LSV Sold
-
08-30-2011, 07:48 AM #5
Here is a pic of the setup at the cooler. I dont know if the drain is after the cooler screen or not. I would hope so, but I have also inlet strainer before the vdrive.
2014 Mojo Surf
2013 Mojo Sold
2010 LSV Sold
2002 OB LSV Sold
-
08-30-2011, 12:43 PM #609 21v LAUNCH
99 Outback LS. Sold
run your engine after you change your oil
68 th Member. WS420,HSE Revolution, OJ 466, Acme1157,1100 sacs,Kicker HLCD's n IX500.4, Supra Coolies
Doug
-
08-30-2011, 03:04 PM #709 21v LAUNCH
99 Outback LS. Sold
run your engine after you change your oil
68 th Member. WS420,HSE Revolution, OJ 466, Acme1157,1100 sacs,Kicker HLCD's n IX500.4, Supra Coolies
Doug
-
08-30-2011, 04:18 PM #8
I won't bother posting pic as I don't think the DD will help you much? But I can if you want.............
2007 Moomba Outback - going, going, GONE
2015 "NOT A MOOMBA"
Why Not? Play Hard! Get wet
-
05-27-2012, 10:56 AM #9Senior Member
- Join Date
- Aug 2008
- Location
- Cottage Grove, MN
- Posts
- 780
I'm thinking about re-routing mine to the transmission cooler like McDye, as mine is currently plumbed how DOCDRS describes his. My question is: Is there a concern on how the hose is routed? If the cooling water is gravity fed, I'm assuming you have to make sure that the hose is routed so that the water does have to go up at any point. Am I thinking about that correctly?
2006 Outback V - Gone
2008 LSV - Gone
2013 other brand
-
05-27-2012, 11:01 AM #10
Mine is t'd into the exhaust manifold quick disconnect line. I'll probably move it one day to a cooler water source.
I have noticed that the hot water drains out on to the prop crossbar on the trailer and has removed the paint when it drains down through he seal due to the very hot temps.2018 Max with a little extra weight here and there