Results 21 to 30 of 47
Thread: Another Stereo Makeover
-
05-17-2011, 11:42 AM #21
-
05-17-2011, 12:10 PM #22
-
05-17-2011, 12:13 PM #23
Great job Al, nice and clean!
What LED did you use to connect up for the ACR? I need to do the same.2007 Mobius LSV
-
05-17-2011, 01:35 PM #24Have you used this set-up with the engine running yet? I have a similar cord that I use to run video from my iPhone into the nav unit in my car - the issue I have is that when the car is running and I charge through USB I get terrible noise. The solution I found was to use the 110v charging block plugged into an inverter.
Thanks again for the ideas Al!So when is this "old enough to know better" supposed to kick in?
2001 MobiusV - Slightly Modified...
-
05-17-2011, 03:03 PM #25
Thanks for the kind words guys.
Yes, still have to make labels for the switch and the ACR LED.
There are many installs on this forum that look way, way nicer than mine whereas I took the easy route. Tried to use as many of the existing panels as possible, keep things simple, and did not go through the trouble of hiding every last cable, etc. I honestly just don't have the time.
That's right. Got it here. Thanks to Razzman for that tip.
http://www.brainydeal.us/Compact-Uni...source=froogle
I have not tried it with the engine running yet. However, I bought two of these cables and have been using the other one in my car all winter and I don't get any noise at all. It works perfectly.
I wish the Exile remote knobs could be panel mounted so I could have installed them on the ignition switch panel.
Got it at Baxter Auto Parts for $7. Be sure to wire the positive of the LED to a 12v source and the neg to the LED terminal on the ACR. I did it the opposite initially.Al
2006 Mobius LSV
-
05-17-2011, 03:04 PM #26
-
05-17-2011, 04:38 PM #27
-
05-17-2011, 05:06 PM #28
-
05-17-2011, 09:20 PM #29
The Kicker knob, dissected:
2013 Outback V
-
05-17-2011, 09:38 PM #30