Here is where the sub amp was moved to. This is just aft of the fresh air chaise. It's held on by two screws at the top that go into the rubrail backing strip. I will probably make a second amp rack at some point for the sub amp but this will do for now. The plug is for the on board charger.


Next, I installed a Stinger voltage display at the helm and hooked it up to the stereop batts so that I can keep an eye on how much juice they have left. I installed a toggle switch where the horn's push button reset used to be. Finally, I installed a remote LED that is connected to the ACR so I can monitor what the ACR is doing.


Closer shot of the Stinger voltmeter, the on/off toggle switch, and the green remote LED for the ACR.


Close up of the Stinger.