Results 1 to 10 of 22
Thread: Thru-Hull Drilling - Bit to use?
-
03-13-2011, 06:17 PM #1
Thru-Hull Drilling - Bit to use?
I need to know what type of drill bit to use to drill a 1' hole for a Thru-Hull Intake for an additional ballast pump.I am concerned about chipping the finish. I would assume you would drill it from the outside. I am looking at the WakeMAKERS.com Complete Impeller Pump Ballast Kit.
07 LSV
-
03-13-2011, 07:27 PM #2
Any wood holesaw will work.... tape the outside and drill in reverse( i do the whole hole in reverse)... i would start on the outside then switch to inside and drill about an eighth inch then go back to the outside and. Finish the whole.... this way the inside will not split/splinter when u push thru.....
-
03-13-2011, 07:30 PM #3
Chamfer the hole as well... so u dont get chips and stress cracks..
-
03-13-2011, 09:10 PM #4
Thank you!
07 LSV
-
03-17-2011, 04:46 PM #5
I used a diamond hole saw use for tile to get through the gelcoat then drilled through the rest forward with a regular wood bit much quicker
I figured if it wont chip ceramic tile it shouldn't chip the gelcoat2007 Outback V
-
03-17-2011, 08:48 PM #6Senior Member
- Join Date
- Jan 2008
- Location
- Pensacola, FL
- Posts
- 1,585
Everything posted above. Use tape on the hull prior to starting, start on the outside. The drill bit will work its way through, then finish from the inside. Start both sides in reverse. Once done, use some sand paper and round (or chamfer) the edges of the gel coat, this will help prevent gel coat cracks. Measure several times, you only get one shot.
1997 MasterCraft 205
2008 Moomba Outback
1999 MasterCraft Sportstar OB
1992 MasterCraft 205
1999 Malibu Response LX
1987 Marlin Magnum Skier
-
03-18-2011, 02:09 PM #7
-
03-18-2011, 02:23 PM #8
^^^^Pilot hole, much easier to repair than a big 1" hole if its wrong
Hey, Its Moomba time
Its all about the dash - enjoy the dash, as that is your time between the dates
13 Mobius LSV-sold
08 Mobius LSV-sold
03 Mobius LSV-sold
life is about finding the balance between being a responsible adult and staying young at heart
-
03-18-2011, 02:39 PM #9
-
03-18-2011, 03:28 PM #10
I just drilled mine in reverse the whole way thru from the outside.. pretty simple. beer always helps the nerves.... pic in my ballast upgrade thread..
A Day at the Lake...Priceless
A Day in Powder...Endless
Joe V
2012 Möbius XLV~ Loaded & Exiled
2007 Outback V ~ sold