need some help!

[outbackv]

ya ill post some pics as soon as i get home! installing them is not as easy as it sounds and yes it is the same system as the factory just you have to bend the actuators to fit the plate not much only about 15 degrees but they are very difficult to bend!!! im pretty much an expert now on bennett trim tabs after all this

btw the guys at bennett are awesome very helpful!

reason for replacing is the whole set up is the hinge holding the plate got a tiny offset bend in it as well as the plate and do to the way the bend is it is you can just hammer it out and i dont

so id like to replce the whole plate set up and was just wondering if anyone has used lenco tabs and just getting ideas of other manufacturers and what not

thanks the the replys