Results 1 to 10 of 44
Thread: Quick and cheap mod!
Threaded View
-
07-24-2013, 01:46 PM #25
Quick and cheap mod!
There are two screw posts on the back of each gauge. There is a retaining bracket that the screw post go through and are held down with a tiny nut and washer. Unscrew the nut and washer and the "bracket" will be able to be removed then just pull out the gauge. I did it by hand but would recommend a small socket or wrench because some of those screws were pretty tight. I had a set of wire strippers for another project I was doing and had to use them to try and free up the nut. You will also need pliers to turn the plastic plug to get the bulb out.
Sent from my iPhone using Tapatalk 2SOLD! 2011 Mobius LSV 325HP EFI
Digital Cruise Pro, Wakeplate, Kenwood KM550U and KCA-RC107MR x2, Kicker ZXM700.5, Kicker 6.5 Cabins, 10'' Kicker CompVT sub, Wetsounds SYN 4, Wetsounds REV10s, Wetsounds WS420Q, Gravity VI Surf Ballast, Acme 537
Board: '12 LF Harley (Monster) 139
Her Board: '11 Ronix Krush 128
Kids Board: '13 Ronix Vision 120
Skate: LF Faction 44
Surf: LF Custom Quad & XXX
Tow Rig:
2011 Toyota Tundra CrewMax TRD Magnetic Grey
3/1 Truxx Lift, and some other stuff...