Installed wake makers direct fit rear bags. Now what

[Mxmark4]

Where are the sensors located? Im assuming my craz has them as well so I guess I may need to move mine up more too?

[HFarr]

Behind the back or rear , stern, panel of each bag. On the Makai anyway.

Sent from my SM-G781V using Tapatalk

[Tommy2slow]

Where are the sensors located? Im assuming my craz has them as well so I guess I may need to move mine up more too?

You should be able to see the OEM vent tubes tucked up under the gunwhales in each rear locker. Follow those back to your bags and you’ll find the sensors.

[bobby1110]

I have the OJ 950 prop on the boat now and as a spare prop I have the OJ 945

[HFarr]

You should be able to see the OEM vent tubes tucked up under the gunwhales in each rear locker. Follow those back to your bags and you’ll find the sensors.

This is where they are on my 21 Makai. Photo of the stock bag location setup. Sensor is the piece near the top on the black pipe in the middle.

Sent from my SM-G781V using Tapatalk

[bobby1110]

do you think t OJ950 that is on the boat is the correct prop with the added weight?

[HFarr]

That is a 15x13 pitch? It should have plenty of low end torque for you at low to medium elevation.

Sent from my SM-G781V using Tapatalk

[Hayden]

That is a 15x13 pitch? It should have plenty of low end torque for you at low to medium elevation.

Sent from my SM-G781V using Tapatalk

0.130" cup as well! depending on your pitch, speed and altitiude you could pull 6k np