Results 1 to 4 of 4
Thread: Backlit sign
-
05-08-2021, 02:21 PM #1
Backlit sign
Anyone ever installed this before? Do you cut a hole in the plastic and let the led show thru the hole to the sign or just somehow mount the sign with the led right behind it WITHOUT cutting a hole?
Mike
2013 Outback V
- ballast: 900# rears / 400# center / 650# IBS
- audio: Exile SXT9Q x 2 towers / Kicker KM65 x 6 cabins / Xi 12 sub / Javelin & XM15.4 amps / ZLD
- FAE
- DIY suckgate
2003 SeaRay 182 -- gone but not forgotten...
-
05-08-2021, 04:47 PM #2
Lots of talented folks on this forum so someone will have some good advice but that illuminated sign was stock on Moombas for awhile. I think it was dropped for 2021. My 2020 Mojo came stock with it.
2020 Moomba Mojo
2008 Mastercraft Prostar 197 40th Anniversary
Owner Ness Lake Watersports
Wakemakers “Exact Fit” Bags + Lead = 4,700 ballast
Audio by Wetsounds, MTX, JL Audio, Clarion
15 X 13.00 ACME prop
-
05-08-2021, 07:32 PM #3
The LED is made with the housing. It believe it’s just stuck on there with backing tape. Of course you’ll need to drill a small hole behind it for the wires to pass thru.
2019 Moomba Max "MOOMBAE"
Mods: Wakemakers upgrade + 500 lbs of lead
2016 Yamaha AR192 - sold
-
05-08-2021, 08:53 PM #4Mike
2013 Outback V
- ballast: 900# rears / 400# center / 650# IBS
- audio: Exile SXT9Q x 2 towers / Kicker KM65 x 6 cabins / Xi 12 sub / Javelin & XM15.4 amps / ZLD
- FAE
- DIY suckgate
2003 SeaRay 182 -- gone but not forgotten...