Purchased an Topsider oil extractor to do my oil changes since that is supposed to be easier than dropping the oil hose and emptying. I had pushed the hose into the dipstick until I heard it bottom on the oil pan. Sucked a good amount of oil but certainly not 5.5 qts worth. Other have said to push in further to get it to the back of the pan, did that. Was able to suck a little more but not much. Went to remove and its stuck, its like it looped itself inside and has knot. I have tried pulling fairly hard and its no go. I can push more in but it comes back to the same spot.

Any ideas?

I hope I'm not at pull the engine to get the oil pan off. What was supposed to save time could have became a real money suck.

Picture for reference.

https://www.amazon.com/America-5060T...4358626&sr=8-9