Results 1 to 3 of 3
  1. #1
    Join Date
    Aug 2011

    Default Dynamat Noise Reduction Install - Craz

    I installed a Fresh Air Exhaust to my 2017 Craz expect the same noise reduction as my previous Moombas, however this was not the case. This Craz was still loud as hell even with the FEA, we'd still have to yell over the engine noise or turn up the music volume. Not what I wanted.

    I was pretty skeptical about the amount of noise reduction from installing Dynamat, but overall it really seemed to help.

    The Dynmat adds heft/thickness/sound deadening to the engine compartment.

    1. Removed the carpet from the backside of the bench seat engine compartment.
    2. Installed 2 layers of Dynamat, then 1 layer of Dynapad, then reinstalled the carpet using contact cement.
    3. Repeat the same layers for the lower bilge access panel - (This is where a lot of noise comes from).
    4. Used the leftovers to cover the engine panel dividers.

    $278.24 for the materials and 2-3 hours for the install.

    (1) Dynamat 10455 18" x 32" x 0.067" Thick Self-Adhesive Sound Deadener with Xtreme Bulk Pack, (Set of 9)
    (2) Dynamat 11102 Dynaliner 32" x 54" x 1/4" Thick Self-Adhesive Sound Deadener
    2002 Moomba Mobius LSV - Sold
    2006 Moomba Mobius LSV - Sold
    2017 Moomba Craz - Enzos, Lead

  2. #2
    Join Date
    Nov 2016
    Knoxville, TN


    I did similar on the new boat, but just used cheap amazon sound deadening mat. Put it in the transmission access area and the panel between the rear seat and engine. Made a big difference and only spent around $50. Figured the carpeted panels were insulated enough. Now, with FAE and the mat, at 30mph can carry on a conversation with the windshield closed.
    2018 Supra SA400 aka The Ron Burgandy
    2011 Sea-Doo Wake 155
    2015 Mojo Surf, sold...2013 Axis A22 Recon Edition, sold...2010 Axis A22, sold...2007 Maxum 180sr3, sold

  3. #3
    Join Date
    Aug 2011
    Commerce Lake, MI


    I literally just did this today, but I just used Noico on the transmission cover. I removed it and put the sound deadener all over the inside of it. I also bought a waterproof adhesive foam from Noico (both from Amazon) but I wanted to see if just the 1st layer would be enough.

    I will contemplate pulling the carpet and doing the back seat wall too but that is going to be a far bigger job.

    Sent from my iPhone using Tapatalk
    2017 Moomba Craz

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts