Speaker Box for Kicker Sub

[Surgical_ass]

Well against good advice I made a 5 sided box with the original front. I had to shift the box over and turn it a little side ways due to the steering cable. A little trial and error but it worked. Got a good seal around the plastic mounting board and box. Used pan head screws with washers and a bead of silicone. I ported the box per the instructions on the kicker site. It made a huge difference!

Now here are my questions
I monkeyd a little with the amp setting not immediately realizing that the settings were probably correct from the factory. I have the kxma800.5. I was able to set the gain confidently on amp 1 and 2 using the downloadable tones. I was unable to get the sub gain to light up with the -10db tone reccomended for subs. It would light up with the 0db tone tho. Amy thoughts why it wouldn't light up with the -10?

Here's where I really pulled a DA move. I screwed with all the crossover settings. Ive looked up where people say where they sould be set but it seems that everyone suggestions are a little different. without proper equipment I'm just eyeballing it.

Sub setting- the sub sonic is set to 30 and the low pass is set to 80 (ish) the eq is around 17
Amp 1&2 I cant remember off hand where they are but I have a feeling they are incorrect. The switches are both on HP and 1X. What should they be set on? Would an audio shop be able to take my amp and set it appropriately with their devices?

I have the stock kicker speakers (6) but will most likely upgrade to the revo 6. Would an upgrade require me to readjust the amp gain crossovers?

[MLA]

What should they be set on? Would an audio shop be able to take my amp and set it appropriately with their devices?

Yes, but they will need the enclosure specs, as in what its tuned to, in order to tune the amp's woofer chnl to its most optima.

Would an upgrade require me to readjust the amp gain crossovers?

No. Both the OEM speakers and Revo's will handle the amp's 50W rms wattage. If the cross over is ideal for one, it will be perfect for the other.

[Surgical_ass]

Yes, but they will need the enclosure specs, as in what its tuned to, in order to tune the amp's woofer chnl to its most optima.

Can you give me an idea of roughly what the crossovers should be set at. Not looking for perfection at this point. Now I'm afraid that I have them set completely wrong and risk damage to the speakers. My main concern is the 6 cabin speakers. I feel that I have the sub mostly dialed in. I have the OEM 6 kicker cabins and kicker kxma800.5 amp. (Amp 1 &2 settings) Anything to get me pointed in the right direction is greatly appreciated. Thank you!