How-to: Winterize your Indmar Assault 325/340

[MJHSupra]

With something like this. Call to get the right part #. GM vs Ford.

https://www.skidim.com/FLUSH-PRO-125/productinfo/DP7/


I've seen others make their own.

Sent from my P00I using Tapatalk

[AtTheRiver]

Thanks for the replies and have abandoned the simple just run with the pink stuff.

Did some more searching and came across this from Indmar: https://indmar.wpengine.com/wp-conte...sed-Models.pdf

[Zim]

Thanks for the replies and have abandoned the simple just run with the pink stuff.

Did some more searching and came across this from Indmar: https://indmar.wpengine.com/wp-conte...sed-Models.pdf

Yeah that's a good way to crack a block.

[Mjhknox]

Thanks for the replies and have abandoned the simple just run with the pink stuff.

Did some more searching and came across this from Indmar: https://indmar.wpengine.com/wp-conte...sed-Models.pdf

Good find on the PDF. Thanks!

[Karl]

manifold.jpg

Just did my 2014 Mojo yesterday with a 330 assault. The Indmar manual had this pic for the hose that connects the manifolds, but I can't find it on mine. There were two hoses coming off the front of each manifold that went to a T-valve that had a 3rd drain hose, near V drive. This was all I could find coming off the manifolds. Am I missing something? Just got the boat this summer, so first time doing winterization, don't wont to miss something.

[AtTheRiver]

manifold.jpg

Just did my 2014 Mojo yesterday with a 330 assault. The Indmar manual had this pic for the hose that connects the manifolds, but I can't find it on mine. There were two hoses coming off the front of each manifold that went to a T-valve that had a 3rd drain hose, near V drive. This was all I could find coming off the manifolds. Am I missing something? Just got the boat this summer, so first time doing winterization, don't wont to miss something.

Same for me. No quick connect, just a T.

[AtTheRiver]

One more tip for winterization. I spray all my vinyl, cup holders, areas under seats / lockers with a mildew blocker before buttoning up the boat.

[DOCDRS]

manifold.jpg

Just did my 2014 Mojo yesterday with a 330 assault. The Indmar manual had this pic for the hose that connects the manifolds, but I can't find it on mine. There were two hoses coming off the front of each manifold that went to a T-valve that had a 3rd drain hose, near V drive. This was all I could find coming off the manifolds. Am I missing something? Just got the boat this summer, so first time doing winterization, don't wont to miss something.

The hose that comes off the T goes to the dripless seal. At least it did on my 09. Its not a good setup as hot water is going to the dripless shaft seal ( causing dripless housing expansion and dripless to become a drippy shaft seal.) This in turn makes the exhaust self draining iirc. I cut mine put a ball valve on it for draining and re routed the dripless cooling off the tranny cooler for cold water.

[nscott]

i have a 2003 supra santera and am trying to figure out how to get to the starboard side block plug. its not open like the port side as there is a walk way. Anyone have any insite on how they did it?

[Zim]

i have a 2003 supra santera and am trying to figure out how to get to the starboard side block plug. its not open like the port side as there is a walk way. Anyone have any insite on how they did it?

Does it look like this?

santera.jpg


That does look like a PITA.