Results 11 to 15 of 15
Hybrid View
-
06-24-2014, 10:36 PM #1
How To: Replace your trailer axle seal
2008 Supra 21V-Currently For Sale
-
07-01-2014, 12:45 PM #2
How To: Replace your trailer axle seal
When tightening the spindle nut I install a tire to make it easier to turn. I spin the wheel and crack the nut tight with channel lock pliers and the back it off half a turn. I repeat this 3 or 4 times and then I tighten
It down, then back it off about a quarter to one third turn. You don't want it all the way tight because then there is no room for heat expansion. Also just pack everything with as much grease as possible. I always fill the hub before I slide it on the spindle to ensure there is grease all in there and then fill that vault cap up about 3/4 full
Sent from my iPhoneDavid
2017 Moomba Mojo Max Surf Edition, 2 Pair Wetsounds Rev10s powered by an SD2, 6 pair Wetsounds XS650M and Wetsounds XS12 powered by SD6 all controlled by a WS420. 2 Lumitec SeaBlaze X2 Spectrum underwater lights
SOLD***2008 Mobius LSV, Gravity III , Wake Plate, Z5, Exile SX65c's, Exile XM9s, Exile XI12D, Exile Javelin, Exile 30.2***SOLD
-
07-01-2014, 01:59 PM #3Senior Member
- Join Date
- Jan 2011
- Location
- Western PA
- Posts
- 100
I agree, I tighten the nut with channel locks till it is pretty tight, back it off a ways, then hand tighten to where the cotter pin will go thru.
2017 Moomba Craz
400 Indmar Rapter 6.2L
"X-ceeding Limits"
2004 Supra 22 Launch SSV-crushed by a massive oak tree. RIP 4/1/2023
325 Indmar Assault 320 HP
"One more hour"