Results 1 to 10 of 13

Threaded View

  1. #9
    Join Date
    Feb 2010
    Canton, Ga / Lake Lanier


    No amp? Is it a Kenwood radio?

    Even if you did have to wire it up it's pretty easy. All of the wires from the new HU are labeled. They should be on the old one too. Just disconnect the harness from the stock radio and take the old HU out. Then, disconnect each wire one at a time from the old harness and connect it to the new one. The color scheme should be the same or at least they should be labeled like Front +, Rear -, etc...

    If you are running all 6 speakers off of the head unit it may be cutting out at the high volume due to the ohm load. You should look into getting a 4 channel amp to power your inboats and free up your radio...

    Sent from my iPhone using Tapatalk
    Last edited by E4NASH; 07-09-2012 at 02:24 AM.
    SOLD! 2011 Mobius LSV 325HP EFI
    Digital Cruise Pro, Wakeplate, Kenwood KM550U and KCA-RC107MR x2, Kicker ZXM700.5, Kicker 6.5 Cabins, 10'' Kicker CompVT sub, Wetsounds SYN 4, Wetsounds REV10s, Wetsounds WS420Q, Gravity VI Surf Ballast, Acme 537

    Board: '12 LF Harley (Monster) 139
    Her Board: '11 Ronix Krush 128
    Kids Board: '13 Ronix Vision 120
    Skate: LF Faction 44
    Surf: LF Custom Quad & XXX

    Tow Rig:
    2011 Toyota Tundra CrewMax TRD Magnetic Grey
    3/1 Truxx Lift, and some other stuff...

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts