




Type: Posts; User: MLA
There is one in the head unit.
Ill start by saying, you will not get bass from a tower pod and will end up with a blown driver if you try. Mid-bass? Yes, you can get mid-bass, but its still going to be limited as how deep and how...
With some calculations, you estimate the needed amp/hours to run a given load for a given time. A battery of a given type and group size, will typically have very close Ah. So to really make an...
For better anchor play time, a dee-cycle is best for a house bank. You want to look at its Ah and ignore CCA/MCA values.
Its not an opinion
Scott, you are worried about the bedliner coated feet, yet think im over reacting about the uncoated inside of the ported MDF box?
Are you familiar with story of the frog dropped in boiling water v's the frog dropped in cold water that the burner is then turned on? The uncoated MDF wood is the later.
The MDF will start to...
The uncoated inside bothers me more. The humid environment will take its toll on the MDF in a season or 2, due to the open port.
Kicker KXMA500.4 would be my choice.
Need to know if the amp is also powering a subwoofer.
The speakers currently there, are free-air. Just about any typical full-range speaker, is designed and intended to, have a large air space behind it.
Im pretty confident, that the 15A stereo breaker is not wired through the ignition key switch. In reality, wiring the 2-wire RA70 to the key switch, was a poor decision.
Moving forward, your new...
That 12V source to the breaker is probably seeing a voltage dip due to the engine load. Cranking the engine has nothing to do with it being a constant 12V on the boat side of the main switch. Again,...
What year is your boat? Are you sure the 15S stereo breaker is not already a constant 12V when the main battery switch is on? With that said, if your boat external amps, i would not want to use that...
From an electrical standpoint, you will need to wire in the new power harness for the 770 and then run a new 2-chnl to the in-boat speaker amp and change the input mode on the amp.
Physically,...
Regardless of head unit, Id pull the unit's switched ignition from the key and relocate to a switch.
Wifi, color screen, 4 zone and a woofer output p/zone, DSP if thats your bag.
Interesting that a April 2023 Moomba had HD's but they didnt hit the general market till June 23.
I can say, without any hesitation, that one 12 in the same box as another 12 with same wattage,...
Look for a screw or bolt used to secure the interior pieces.
To patch; Get a tube/towable patch kit.
For those of you with the Fusion media units and poor sub output. Before you get too krazy on doing anything, you have to go into the sub settings and up the factory default cross-over to its highest...
Im interested in what you had prior to the Rev-10HD and you didnt just go straight to the rev-12HD?
If you removed a Revo-10FA and cut a larger hole and installed a Revo-12FA and now plain to...
This boat will NOT support a free-air woofer unless you fab'd a new facade that wend floor to the backside of the helm so to create 100% air isolation between the back of the woofer and the front....
The location is mostly irrelevant to the use of a Free-air or acoustic-suspension (small sealed enclosure) woofer. The two woofers are build differently and its not ideal to interchange their...
I dont recall it looks like, but you might be able to answer your own qustion.
1) I would not add a 2nd woofer into the system while leaving the 1st woofer setup with the 2 serious flaws it has. ...
Larry,
If I understand the model and setup you are referring to, those Supras have a complete wall that the woofer is mounted to. The 2nd issue with the moomba, is that the wall is open at the...
The KM is a great sounding and performing marine 10". So putting it in a proper small sealed enclosure will be a night n day difference.
A custom enclosure is the best wat to go. not only will it...