Search:

Type: Posts; User: MLA

Page 1 of 20 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    22
    Views
    12,037

    When you go from the RUN to ACC position and then...

    When you go from the RUN to ACC position and then from the ACC to the CRANK/RUN positions, there is an interruption in the switched 12V turn-on signal to the head unit. So it shuts off and back on....
  2. Thread: A couple issues

    by MLA
    Replies
    9
    Views
    757

    Solid or flashing badge on the amp? This gives a...

    Solid or flashing badge on the amp? This gives a code that offers some direction. Protect mode can be an internal amp issue, but there are also a number of external influences. High or low voltage,...
  3. Thread: Kicker KMS67

    by MLA
    Replies
    7
    Views
    1,133

    In Bridge mode, the amp will offer solid wattage...

    In Bridge mode, the amp will offer solid wattage for either the current or new setup.

    While the KMS67 is one of the best sounding 6.5" HLCD ever, its still a 6.5" HLCD. They are still pretty hard...
  4. Replies
    4
    Views
    430

    For a cranking battery, get the most CCA or MCA...

    For a cranking battery, get the most CCA or MCA you can get in whatever group size will fit. Odds are, you are working with group-24.

    Are you going to be setting up a dual-bank system with a...
  5. Thread: Kicker KMS67

    by MLA
    Replies
    7
    Views
    1,133

    Whats your amp thats driving the KMT674?

    Whats your amp thats driving the KMT674?
  6. Replies
    48
    Views
    11,187

    Is and has been a wired remote that works off a...

    Is and has been a wired remote that works off a N2K network. Does not have wireless capabilities.

    The wireless puck does allow for zone control, but you have to enter the "zone" mode and then tap...
  7. There are dozens of universal BT receivers on the...

    There are dozens of universal BT receivers on the market. If the head unit has an AUX audio in, then they will work. Rear Aux-in is most ideal.
  8. Replies
    20
    Views
    819

    Yes, thats a great way to word it.

    Yes, thats a great way to word it.
  9. Replies
    20
    Views
    819

    My last conversation with Rob @ LL, was that...

    My last conversation with Rob @ LL, was that their RGB integration module takes the color commands that would go to an LED, and process it and then send out the command to the lights connected to...
  10. Replies
    20
    Views
    819

    If both in-boat and underwater LEDs work in sync,...

    If both in-boat and underwater LEDs work in sync, then it could make sense that both are not working, as the commands comes from the Vision. I also think that the RGB signal to the LL box, would come...
  11. Replies
    20
    Views
    819

    Make sure the rocker switch on the side of the...

    Make sure the rocker switch on the side of the controller did not get bumped to the off position.
  12. Thread: Lighting issues

    by MLA
    Replies
    3
    Views
    208

    So they charged you 3 hours to physically install...

    So they charged you 3 hours to physically install the rings behind the grills thats held on by 4 screws. Well, guess what! Those rings now have to be removed in order to complete the 5 hour wiring...
  13. Replies
    23
    Views
    1,414

    If im not mistake, the pumps are driven by a PDM....

    If im not mistake, the pumps are driven by a PDM. Not sure whats rating is, so adding more pumps or larger pumps, would likely not be plug n ply eclectically wise.
  14. Replies
    23
    Views
    1,414

    The only gain is going to be parallel pumps or...

    The only gain is going to be parallel pumps or higher capacity pumps. With 2 pumps in series, your final flow rate is likely going to be that of the last pump, rather then summed flow rate of the 2...
  15. Replies
    23
    Views
    1,414

    Short answer, yes. I think the biggest hurdle is...

    Short answer, yes. I think the biggest hurdle is going to be having an unused port on the sac/tank for filling/draining.
  16. Thread: Changing prop

    by MLA
    Replies
    10
    Views
    465

    This is actually outlined in the c-clamp puller...

    This is actually outlined in the c-clamp puller directions. You are not supposed to keep loading the puller till the prop pops. You are to load the puller, then smack a couple times with hammer, then...
  17. Replies
    4
    Views
    379

    Heres a quality solution...

    Heres a quality solution https://www.kicker.com/klsr-led-speaker-rings but not sure what your threshold of cheap is, but 2 pair of the Kicker LED rings is less then the ebay add for 4 DS18 grills. ...
  18. Replies
    4
    Views
    379

    If your current speakers are DS18, then thats...

    If your current speakers are DS18, then thats your deal. if you do not have DS18 brand speakers, those will likely not work.

    What speakers do you have? You could likely just add LED rings behind...
  19. Thread: Grounding issues

    by MLA
    Replies
    16
    Views
    1,385

    So different B+ points are ok? Either way, theres...

    So different B+ points are ok? Either way, theres a potential for a voltage differential.
  20. Thread: Grounding issues

    by MLA
    Replies
    16
    Views
    1,385

    As noted earlier in this thread most people to...

    As noted earlier in this thread most people to not understand what ground loop is, thus they only focus the DC B-. Takes two to tango, so dont ignore the B+.
  21. Replies
    11
    Views
    2,677

    So you want to simulate the CD changer so the BUS...

    So you want to simulate the CD changer so the BUS Audio inputs go live?

    Yes, you can plug in a dongle, but in my experience they are unreliable and it does not work for long before the inputs go...
  22. Replies
    13
    Views
    878

    Easy to isolate. Disconnect the RCA. if the noise...

    Easy to isolate. Disconnect the RCA. if the noise is no longer present, its not the cheap amp.
  23. Replies
    13
    Views
    735

    I would not suggest recharging a LiFePo with...

    I would not suggest recharging a LiFePo with anything other then its manufactures suggested charger. Further, then Pro Sport does not allow for charging 2 different types of batteries at once, one on...
  24. Replies
    5
    Views
    463

    Remote battery posts or BUS bars are great for...

    Remote battery posts or BUS bars are great for eliminating excess B- cables of the battery(s) and B+ cables off the back of the switch.
  25. Replies
    5
    Views
    463

    What is a "tower cable"? If the boat has dual...

    What is a "tower cable"?

    If the boat has dual banks, then nothing but the automatic bilge pump should be wired direct to a battery. Everything else should be wired to the common output of the...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4