Activity Stream

*sold* sold

Awesome. Thank you! Yes mine is smooth. Sent from my iPhone using Tapatalk

That was the part number I used for the pulley. I have a local-ish Indmar dealer that ordered both the pulley and the belt for me. Check...

Was the P/N the 551246? I am having the same problem trying to figure out the part number. I see that one on Inboard Online. Just want to make...

This the pulley that failed on me. The bearing seized and the belt ate the plastic.

The half inch drive goes in the square hole on the right. My ratchet did not give me enough leverage. I used a 24" breaker bar and it was easy.

It had a little wobble, so I was going to replace it while I have the belt off. Sent from my iPhone using Tapatalk

How do you loosen the belt tension? I saw online you put a 1/2” drive socket into the tensioner, but it doesn’t seem to move easily like the video I...

Yeah I wasn't excited about it at the time but it was an insurance job so... The other upholstery shops around were $500-1000 less but they would...

Sounds good. We do the 3/2 shortie suits and make sure the driver does not keep us in the water too long on pick-ups and launches.

Hubs are good. Truth be told, I actually pulled all 4 to clean out and replace all the old hybrid grease and check bearings. That is how I broke...

I would also make sure the temperature difference is not due to any low grease in the wheel bearing hubs. Unless they are sealed? Sent from my...

Got the first surf of the season in last week here in Houston. Kids braved the tube but wouldn't commit to board sports yet and wife wouldn't even...

65 degrees yesterday and 5 inches of snow today, Ugh!