Activity Stream
-
Older Activity
-
Today, 12:53 AMLittle Friday night fun. Not sure why I love this thing but sure do. By no means am I good with a slalom, and I’ve had some super hard...45 replies | 2691 view(s)
-
Today, 12:08 AMI agree honestly when you look at just how small those “lakes” are they’re talking about. Most would be considered a pond or large pond. The one...29 replies | 3418 view(s)
-
Yesterday, 10:02 PMJust saw this. https://fox11online.com/news/local/wake-boat-ban-ordinance-passed-for-lakes-in-waupaca-county29 replies | 3418 view(s)
-
Yesterday, 04:17 PMIf the reservoir is still above the hose you are good. It only is an issue if you get air in the system. Just top off the container and you are...13 replies | 587 view(s)
-
Yesterday, 08:52 AMThanks again. The antifreeze burped over a bit but the reservoir is still half full - it should probably be topped off. Is there a procedure to top...13 replies | 587 view(s)
-
07-25-2024, 04:37 PMKinda obvious but it's painted the same color black as the case.4 replies | 171 view(s)
-
07-25-2024, 02:21 PMThanks for that, where is the vent located or is it obvious? Sent from my iPhone using Tapatalk4 replies | 171 view(s)
-
07-25-2024, 11:50 AMI'm pretty sure I just used the existing transducer with my faria depth gauge. It is backlit and has air and water temp sensors (best to run the...1 replies | 53 view(s)
-
07-25-2024, 11:31 AMAnyone have any experience with the depth gauge numbers being faint or hard to read? Is it possible just to replace the gauge or will I also have to...1 replies | 53 view(s)
-
07-25-2024, 10:23 AMThank you for help. Much appreciated.6 replies | 124 view(s)
-
07-25-2024, 10:21 AMAh good deal the relays make it easy. Sounds like just a dead batt then.6 replies | 124 view(s)
-
07-25-2024, 10:08 AMyes, there is a voltage sensitive relay in the boat. So driving around the lake the selector should be in position 1? That is what I've been doing...6 replies | 124 view(s)
-
07-25-2024, 09:50 AMOnly if the two batts match can you run them combined the full time, if not identical (one starting one deep cycle) need to separate while the engine...6 replies | 124 view(s)
-
07-25-2024, 09:36 AMI have a 2006 Mobius LSV. You run on selector 1&2 full time? I assumed the relay would automatically charge the house battery when the starting...6 replies | 124 view(s)
-
07-25-2024, 09:29 AMSounds like a dead battery. I'd get it tested. If both of your batts are identical no need to only run on the 1, leave it combined the full time...6 replies | 124 view(s)
-
07-25-2024, 09:21 AMHopefully somebody has experienced this and can help solve the issued. While I was pulling the kids knee boarding, I adjusted the trim, and when I...6 replies | 124 view(s)
-
07-24-2024, 07:41 AMGreat pics guys! That’s a massive tree too!!!!45 replies | 2691 view(s)
-
07-23-2024, 07:08 PMFinally a contribution from our 4th trip and a couple other Saturdays out. For some reason I didn't take many pics on these last few trips. Kind of...45 replies | 2691 view(s)
-
07-23-2024, 05:51 PMHoldmybeer replied to a thread Rewiring Heater pump to NOT run all the time? Been Done? in Service & RepairNext time just stack ice on the heater core to cool the aluminum. Wouldn't have been the most efficient but 5 degrees cooler would have felt like...7 replies | 217 view(s)
-
07-23-2024, 05:49 PMHoldmybeer replied to a thread Rewiring Heater pump to NOT run all the time? Been Done? in Service & RepairI would want them on 2 different switches. Like Knox said, leave the fan switch on the dash but add a switch under the seat for just the pump. This...7 replies | 217 view(s)
-
07-23-2024, 05:11 PMTest run was this past Sunday. Fill and empty times are way less than the original system. It was roughly a 10-13 hour install. I guessed at which...32 replies | 2715 view(s)
-
07-23-2024, 04:39 PM996scott replied to a thread Rewiring Heater pump to NOT run all the time? Been Done? in Service & RepairI know almost nothing about electrical stuff but I would think that you could unplug the electrical connection from the circulating pump and then tap...7 replies | 217 view(s)
-
07-23-2024, 04:37 PMHFarr replied to a thread Rewiring Heater pump to NOT run all the time? Been Done? in Service & RepairWe watched fireworks from my boat this past July 4th, and it was about 97 degrees with no wind that night. We were roasting while just floating...7 replies | 217 view(s)
-
07-23-2024, 03:50 PMA few shots from the 4th of July and finally got my Hailey girl to ride with me. We went out with some friends about a week ago and our friends 6...45 replies | 2691 view(s)
-
07-23-2024, 03:37 PMKnoxMojo replied to a thread Rewiring Heater pump to NOT run all the time? Been Done? in Service & RepairIf you don't care about heat, just pull your hoses and run a barb fitting between the 2 and unplug your pump. That is what you do when you have a...7 replies | 217 view(s)
-
07-23-2024, 03:00 PM996scott replied to a thread Rewiring Heater pump to NOT run all the time? Been Done? in Service & RepairI would be really interested in this as well. I have replaced my pump once already and a little uneasy waiting for it to happen again.7 replies | 217 view(s)
-
07-23-2024, 01:42 PMThe new ride looks amazing Hak!45 replies | 2691 view(s)
-
07-23-2024, 01:24 PMYes sun was facing towards the transom and lit it up nicely. Gotta love the ultra flake iridescence. Compared to my Max which has hardly any gel...45 replies | 2691 view(s)
-
07-23-2024, 09:46 AMGreat pics! Wild how the blue flips on the transom. Sent from my SM-S911U using Tapatalk45 replies | 2691 view(s)
-
07-23-2024, 08:15 AMBeautiful pictures! And good for you on picking up the floating debris. Yeah, that thing could have at least been a bad gel coat scratcher for...45 replies | 2691 view(s)