WildH
Member

What kind of cruise issues?

Did you pull the plastic top off the helm and mat underneath? I'm getting a fair amount of buzz where that plastic top contacts the fiberglass, but...

FYI...I just tried unplugging mine this weekend and worked fine. No error codes. I just use the timers and overflow.

Keep updates on this. I use hot sauce at the end of every weekend at the lake, but it's not nearly as cheap as your solution. Work on windows?

Here's some video. https://youtube.com/shorts/nrcdB9F0WNA?feature=share Notice the speed bouncing up and down and zerooff is trying to chase...

Perfect. That's exactly what I was wondering. Bigger number is more cupping.

Makes sense. So is 0.15 more or less cup than 0.105? Just not sure how that's measured.

What effect does the cup on a prop have? The 3407 (15.5x13x.0.150) has slightly different cup than the 3892 (15.5x14x0.105).

What do you think should be the "Altitude/Wake" prop? Lower pitch? I swapped to a Acme 15.5 x 13.0. Lost a lot of top end speed, but it does...

Got ya. So does the seat still have the hydraulic adjust? This just adds to it?

Higher pedastel on the captains chair? Do explain! I'd like.mine to be able to go up more rather than using the little fold up booster.

Cool! I think the max needed it. The Makai and Kaiyen are maybe the nicest interiors. If they could replicate that to other models, it'd be sweet.

What would be great is a channel that moves it off to the side. Would.like to see a 12 sub. And JL option vs WS. And...helm material that...

If that's the case you could just get the diameter of the hard tube and buy a piece of PVC and cut the hard tube and splice in a piece. Either way...

Maybe... But it's been doing it since day two so will have to see. It's intermittent. If it happens again, I'll record it so I have some proof....

Me too! Worked fine today though. So that's good.

Checked bus bar and battery terminals. All solid.

I wonder if they can be disconnected or 'hot wired'. With venting and overflow it's pretty easy to tell when it's full.

Very helpful! Thanks.

You got a picture of where the sensors are? I didn't have much issue when I had the stock bags, but with the wakemakers, it's all the time.

I let it cycle and it did it to me. When my wife drives, I'm not sure.

I don't think it can be negative, but it should be a feature. Mine do the same.

I only had it die once, but we do get an issue often when restarting the engine between surfing sets After a restart, and engaging the throttle it...

Do you find this to be a bit annoying? How does the auto off feature know when to stop? Mine stops pretty dang early and when bags are maybe 80%...

So I got everything installed. Couple questions before I give it a go on filing. 1. Putting the check valve between the T and drain port is...

And we typically go through 5 jugs of those every weekend. I'm envious of my brothers set up. He has a massive fuel caddy (200gal?) On trailer...

That big barrel is a nice set up and cheap. Already have the flo fast stuff otherwise I'd maybe check into building. Fwiw here's my set up. ...

I bought a set of these. Haven't installed them yet. Looks like they should be installed on the engine side for sure. Will take a little cutting for...

Garmin is notorious for bad menus!!!! They make a solid product from a hardware standpoint but the software has always left something to be desired....