Activity Stream
-
Older Activity
-
Yesterday, 10:11 PMTry this. ...1 replies | 64 view(s) -
Yesterday, 09:43 AMuse at your own risk but I have used a magic eraser lightly and then polish compound and wax. I emphasize the word lightly.2 replies | 81 view(s) -
Yesterday, 09:25 AM3M makes some marine products (kit) that will provide a light cut, then a polish. Start light before going to anything heavier.2 replies | 81 view(s) -
06-18-2025, 11:27 PMCan someone recommend a product to remove a scuff on the gel coat caused by a surf board. Thanks, Kevin2 replies | 81 view(s) -
06-18-2025, 09:21 PMLooks like the ole alternator but the dust this last weekend. Got a warning that voltage dropped to 11 volts. Any idea where to get one besides the...1 replies | 64 view(s) -
06-18-2025, 11:52 AMDukabor replied to a thread DIY stern thruster concept and preliminary tests in Moomba ModificationsAny additional updates, thoughts on the thrusters?25 replies | 35845 view(s) -
06-17-2025, 07:11 AMStill on the water? Did it no start again?31 replies | 44042 view(s)
-
06-17-2025, 04:33 AMIf you're looking for a modern online casino in Australia, SlotsGallery slotsgallery.casino has everything you need. It boasts an enormous range of...
-
06-15-2025, 12:12 PMI checked the ground from the battery to the block. It was rusted heavily. I backed it out cleaned the threads put some dielectric grease on, and it...31 replies | 44042 view(s) -
06-14-2025, 08:34 AMCoil is new Plugs are new or at least good Wires are good Connections all tight Fuses/breakers good nothing tripped Battery ran for 2 weeks...31 replies | 44042 view(s)
-
06-14-2025, 07:28 AMI am just assuming it's the same problem as last time. No spark getting to the plugs. Will try and figure it out this weekend.31 replies | 44042 view(s)
-
06-13-2025, 11:11 PMDid you determine the no spark to be coil to distributor, or distributor to plugs? Just curious where the problem is starting.31 replies | 44042 view(s)
-
06-13-2025, 06:36 PMChecked all connections to the new switch. Will try to trace the battery wire tomorrow. Everything looks good and feels tight. If I ran a new wire,...31 replies | 44042 view(s)
-
06-13-2025, 06:31 PMMan, that has to be frustrating! Check your switch connection plugs again since you had them apart when you changed the ignition switch out. Maybe...31 replies | 44042 view(s) -
06-13-2025, 06:29 PMNever had mine off before, so I am shooting in the dark about what it looks like,but can you spread a thin coat of RTV silicon gasket maker on it? ...4 replies | 8927 view(s)
-
06-13-2025, 07:54 AMNo spark again this morning ran great started like it is injected for two weeks. Today no spark. It sat for two days, so I primed the carb with a...31 replies | 44042 view(s)
