Activity Stream

I didn't add one, but my radio came with one. I actually use it quite a bit when the boat is in my dock slip. And when I say "I", I mean my kids. ...

That is in beautiful shape. Nice find. You will have fun with that boat

Nice find. If anything, go through it, enjoy it for a while and then flip it. I've contemplated doing that a time or two. A neighbor down the road...

I've read a little about people doing EFI and to be honest i don't know a lot about them. I'll start with the carb for now and see how it goes. ...

I found it in Tennessee. After debating if I wanted to make a 3,400 mile round trip to pick it up and tow it back I decide to just have it shipped. ...

Bringing this thread back. Has anyone added a GPS puck to the 770 for automatic volume conrtol?

congrats... some of the nicest days on the water were on my buddies old moomba boomerang. nothing like a hairpin turn at 30....

Congrats! Sharp looking boat you have there! We tried buying a cross over boat at first before selling our ski boat and are so happy we kept it. ...

Instead of rebuilding the carb (easy enough) I would see if an EFI kit can be had for the long term. Might not be worth the coin but at least worth...

Nice looking boat. Those things look like sharp pointed daggers! LOL! Where did it come from? Sent from my SM-G781V using Tapatalk

Cool. Funny thing after driving a big heavy wake boat, these ski boats are like sport cars. Acceleration and tight turns. But in the long run,...

Nice! Enjoy.

*sold* sold

Awesome. Thank you! Yes mine is smooth. Sent from my iPhone using Tapatalk

That was the part number I used for the pulley. I have a local-ish Indmar dealer that ordered both the pulley and the belt for me. Check...

Was the P/N the 551246? I am having the same problem trying to figure out the part number. I see that one on Inboard Online. Just want to make...

This the pulley that failed on me. The bearing seized and the belt ate the plastic.

The half inch drive goes in the square hole on the right. My ratchet did not give me enough leverage. I used a 24" breaker bar and it was easy.

It had a little wobble, so I was going to replace it while I have the belt off. Sent from my iPhone using Tapatalk

How do you loosen the belt tension? I saw online you put a 1/2” drive socket into the tensioner, but it doesn’t seem to move easily like the video I...

Yeah I wasn't excited about it at the time but it was an insurance job so... The other upholstery shops around were $500-1000 less but they would...

Sounds good. We do the 3/2 shortie suits and make sure the driver does not keep us in the water too long on pick-ups and launches.

Hubs are good. Truth be told, I actually pulled all 4 to clean out and replace all the old hybrid grease and check bearings. That is how I broke...

I would also make sure the temperature difference is not due to any low grease in the wheel bearing hubs. Unless they are sealed? Sent from my...

Got the first surf of the season in last week here in Houston. Kids braved the tube but wouldn't commit to board sports yet and wife wouldn't even...

65 degrees yesterday and 5 inches of snow today, Ugh!

Great tip. And yes, I have an oil extractor. Didn’t even think about it. Sent from my iPhone using Tapatalk

If you have an oil extractor for your boat already just it. You can have someone putting fluid in as you pump the extractor. Next time anyone...

Yep. 3 bolts, hub on pump pulls back just enough to run the flat belt through. Bolt pump back to balancer. The bolts completely suck to remove. ...