I could t find one from same seller that was RGB. Wasn't a deal breaker for me though. I only have blue lights in my boat https://uploads.tapatalk-cdn.com/201...0bcee3c167.jpg
Sent from my SM-G960U using Tapatalk
Printable View
I could t find one from same seller that was RGB. Wasn't a deal breaker for me though. I only have blue lights in my boat https://uploads.tapatalk-cdn.com/201...0bcee3c167.jpg
Sent from my SM-G960U using Tapatalk
So I finished up the stereo install over the weekend pulling some late nights so I could take the boat out last Sunday. Everything worked..... except a major air leak from were the sub box meets the helm wall on the bottom edge. It sounded terrible!
Remember I said I should have cut the hole for the sub a little lower....the box not being able to be pushed upwards enough was keeping it from sealing at the bottom.
To fix I ordered one of these: Atrend Universal MDF Constructed Spacer for 12 Inch Sub Boxes- Adds 3/4" to Decrease Woofer Depth https://www.amazon.com/dp/B0013NWD12..._CMegBbEX0EYEH
and cut a little bit off the top of it so it would make a perfect circle with the hole I cut. Then I drilled 8 small holes and counter sunk 4 short screws in to hold this to the wall, and 4 long screws going through the ring and into the box to hold it in place. Before I had the sub mounting screws going through the helm wall and into the box. Put some silicone around all seams for good measure.
Ignore the god awful hack job hole I cut, thank god it’s hidden lol.
https://uploads.tapatalk-cdn.com/201...464813e40c.jpg
https://uploads.tapatalk-cdn.com/201...383d93dd36.jpg
Other than that this thing bumps hard! This system is crazy loud, I couldn’t be happier.
And good lord those rev10s scream with 300watts per speaker!!!
https://uploads.tapatalk-cdn.com/201...7015d7c244.jpg
Going up to the in laws lake house this weekend so I’m hoping to finish up round 1 of the rgb LED install tonight or tomorrow night.
Been there, done that. The cupholder's we're recommending look WAY better than plastic tubes under the lip of the cupholders. Plus you get a nice glow from the translucent barrel and don't get the "pearl necklace" effect. I did the translucent tubing around my subwoofers though, but made sure I got the LED strips with a higher concentration of LED's (1 LED per CM, vs most strips that have like 1 per inch).
I've never seen RGB versions of the cupholders we suggest. But pick your fav color and just go with them. they look great and Malibu even uses them in their flagship M235.
If it's the 800/8 pushing them I bet they sound amazing
Sent from my SM-G960U using Tapatalk
Yep, four 8.8’s on a JL 800/8. They’re clean and get loud, even at 85’ off.
There’s no replacement for the mid-bass on the 410’s though. Having 2 10’s moving air up there is hard to beat. But for the money, unless they all fry, I wouldn’t make the switch. Sound quality wise the JL can’t be beat.
It’s still amazing to me that JL hasn’t built something to compete with wet sounds.
How sick would a 410 pod with 2 w6v3’s be?! Lmao
Was there a tower between this one and the newest? Could be possible ....
https://uploads.tapatalk-cdn.com/201...86cdca0827.jpg
Sent from my SM-G928V using Tapatalk