Hayden
Senior Member

If you're wanting to use it as a surf boat, you either need to A) get a lot of people on it or, B) at least do the wakemakers upgrade for the rear...

I didn't have enough time to get exact numbers on the front bag setup but it is very close to the rears now. I will post up this info the next time I...

I've followed this since Jon (SC) posted it and have had good results. WP-regular=0, WP-goofy=0-15. Original thread is here: ...

Very nice. Agree with this.

What will be the primary activities you intend to do with the boat? Skiing/surfing/wakeboarding/tubing/cruising?

This is the thread you want.... https://forum.moomba.com/showthread.php?35682-Pull-out-heater-hose-upgrade

The difference this makes for a session cannot be understated. Flat water, no wind is a completely different experience to a "regular day".

Nope, just plumbed in the two extra bow bags that I was filling with an over-the-side tsunami pump. Makes transitioning from surfing to tubing...

I'm ashamed to admit that I have never seen this done with wake surfing, only wakeboarding. I hadn't considered it at all. You would need a...

In my opinion, this depends; from best case, A) 100 lbs kid on a medium or long board, I would say 8-9deg pitch and 3600-4100 rpm, to worst case, B)...

I will let the engine guys cover this but I can say from experience with my previous boat that you do not want to shift quickly from forward to...

0.130" cup as well! depending on your pitch, speed and altitiude you could pull 6k np

I'm not a fin expert but I did ride a 4'6 Doomswell Neo with Blackstix F4's for the first 2 years of my surfing. I weighed 165lbs at the time and...

If you want to cover all your bases, after you've reinforced the engine dividers if you decide to do that, pull everything out of the boat (except...