View Full Version : Black mold spot removal

04-02-2013, 11:53 AM
So trying to get ready to go out for the first time this year. The black seems to have broken out it a black mold spot rash.

Anyone have tips to remove these spots?

Any ways to help prevent further out brakes?

04-02-2013, 12:20 PM
Try other mild cleaners first. But, if you have to go harsh, use "Totally Awesome" from the Dollar Tree and a magic eraser. Be careful as the magic eraser is abrasive. Be sure to follow up with some 303 protectant.

04-02-2013, 10:34 PM
thanks ill try that. which 303 are u talkin about

04-03-2013, 08:31 AM
mild cleaner and then park it in the sun for a few days

04-03-2013, 12:25 PM
thanks ill try that. which 303 are u talkin about

I get this at Boat US but I think you can order it from Wally's with free shipping to store if they don't have it:


04-04-2013, 12:51 PM
Thank ill clean it agin park it in the sun then hit it with 303 protectant

04-05-2013, 12:09 AM
I wonder how a steamer would work for something like this? I would think for sure it would kill off the mold spores, but you might still be left with the black mark that requires a cleaner anyways. I think it would be safe for carpet, but the heat may crack vinyl depending on where you have it.

If you got one, give it a try. Be sure to dry in the sun afterwards since you are still adding moisture that surrounding carpet would pick up and any remaining spores would thrive on.

04-05-2013, 10:01 AM
I have had great success with Starbrite Mildew Stain Remover. Follow the directions, it seems to work fine that way. Follow up with a vinyl dressing like 303.

04-08-2013, 03:40 PM
This may be a little extreme, but I had some bad spots on my yellow sections a few years ago. They looked purple and no amount of scrubbing or chemicals on the surface seemed to get them out. I got some very tiny needle syringes from the medical clinic I used to visit, did a 50/50 mix of water and bleach, and then injected it into the spots on the cushion. I held the needle at an angle almost parallel to the surface, if that makes sense, to avoid having a pin hole show. Did 3 or 4 spots and it actually worked pretty good and didn't get brittle. I figured I'd rather have a slightly lighter spot (bleached) than a dark spot showing.