Results 151 to 160 of 166
-
11-15-2018, 01:55 AM #151
Great looking boat! I really like the accents!
I am currently in the process of ordering a boat from Rinkers and I was wondering how well were they able to match your REV10s to the boat? Has the paint held up well on them? I am just concerned that since I am ordering my boat with the tower accents white that they won’t be able to match the white perfectly and that will drive me nuts. TIA
-
11-15-2018, 10:43 AM #152
Thanks, the color matched REV10s and bimini arms add a pop of color on the tower and receive a lot of compliments.
Rinker's did a phenomenal job with the color accents and will take care of you, they have the PPG codes from SC and the Sundance Yellow is totally spot on. After two seasons, the paint has held up extremely well but I also protect the REV10s with Speaker Sox when not in use.
Just make it clear which white you are wanting to match (gel coat vs tower accent) just in case there are tonal differences between the boat and the tower.2017 Moomba Craz Surf Edition
Flow 2.0 Surf System w/ AutoWake™
5,600 Lbs Ballast - Enzos + Lead + Sumo
Wet Sounds REV10s + REVO12-XXX
-
11-16-2018, 01:17 AM #153
-
02-09-2019, 02:07 PM #154
....spring upgrade time, sexy ass surf pipe
Sent from my Note9 using Tapatalk2017 Moomba Craz Surf Edition
Flow 2.0 Surf System w/ AutoWake™
5,600 Lbs Ballast - Enzos + Lead + Sumo
Wet Sounds REV10s + REVO12-XXX
-
02-09-2019, 05:58 PM #155
-
02-09-2019, 06:05 PM #156
-
02-09-2019, 11:42 PM #157
LOL!! Those are the easiest!!
Sent from my iPhone using Tapatalk2019 Makai
Raptor 450 w/ 1.76 Trans
WakeMakers 1350s in the rear & 1K in Lead
-
05-29-2020, 06:59 PM #158
Figured I'd revive this old thread....
Installed an ACME 2937 15 X 11 prop and can't wait to try it out with the boat slammed.
Hat tip to David for letting me borrow his prop puller!
Sent from my SM-N960U using Tapatalk2017 Moomba Craz Surf Edition
Flow 2.0 Surf System w/ AutoWake™
5,600 Lbs Ballast - Enzos + Lead + Sumo
Wet Sounds REV10s + REVO12-XXX
-
05-29-2020, 08:56 PM #159
Sweet!! I know you are running slammed so I assume this is to help you with all that weight?
Sent from my iPhone using Tapatalk2019 Makai
Raptor 450 w/ 1.76 Trans
WakeMakers 1350s in the rear & 1K in Lead
-
05-29-2020, 09:11 PM #160
Yessir.
The OJ 945 15 X 13 was good with Enzos & lead but kinda struggles when I add a 1000lb sumo sac. It can barely get to 11mph.
I told the ACME rep I primarily surf and run around 5,600lbs of ballast, the 2937 was the recommendation even though Wakemakers prop-finder suggested the 2419 15 X 12.
We may not have high altitude but the rep reminded me our hot humid air is a heat soak for the Raptor.
I'm guessing I'll top out around 27-28mph but I don't really care about that.
My crew tends to run on the small side so we sack it out.
I hope to do some water testing this weekend
Sent from my SM-N960U using Tapatalk2017 Moomba Craz Surf Edition
Flow 2.0 Surf System w/ AutoWake™
5,600 Lbs Ballast - Enzos + Lead + Sumo
Wet Sounds REV10s + REVO12-XXX