Results 41 to 50 of 57
Thread: Doing it backwards -Max Purchase
-
02-26-2019, 12:12 PM #41
-
02-26-2019, 01:12 PM #42Senior Member
- Join Date
- Jun 2016
- Posts
- 288
-
02-26-2019, 01:32 PM #43
I was curious because when I demoed the Makai we loaded it up with all 4k of Ballast, 1k of lead and had 6 adults (1K) so say 6K total and got to wakeboard speed (21.5) a lot easier than I thought it would have. That boat had the 400 with the wake prop. I don't have a dog in the fight I am just curious to know if the hull design differences and 2' in length between the Max and the Makai make that much of a difference when it comes to planing. I figured that with the Max being shorter and lighter that it would be able to achieve the same no problem.
2019 Makai
Raptor 450 w/ 1.76 Trans
WakeMakers 1350s in the rear & 1K in Lead
-
02-26-2019, 02:53 PM #44
I’ve had my max loaded with 4200lbs and 10+ adults and she said negative to getting on plain (at least not in the amount of time I was comfortable leaving the hammer down and letting it struggle lol).
2018 Murder Max
2008 Outback V-Bought new; sold in 2018
-
02-26-2019, 03:24 PM #45Senior Member
- Join Date
- Jun 2016
- Posts
- 288
-
02-26-2019, 04:15 PM #46
Isn’t there a launch setting with Autowake that helps with that?
2019 Moomba Max "MOOMBAE"
Mods: Wakemakers upgrade + 500 lbs of lead
2016 Yamaha AR192 - sold
-
02-26-2019, 04:23 PM #47
-
02-26-2019, 04:50 PM #48
Yes. I recall Matt touching on this and if I remember right Autolaunch is active as long as you have Autowake ON, have cruise set and are NOT in Surfmode. I believe the surf plates go down to 50% and will stay down until the boat reaches a certain % of the set speed then they will retract to 0%. That is all in addition to what the wake plate does normally which I believe at rest is at 100% and adjusts from there depending on speed. I might have the %s off but I am pretty sure that is how it works. Someone correct me if I am wrong as I hear to learn too!
2019 Makai
Raptor 450 w/ 1.76 Trans
WakeMakers 1350s in the rear & 1K in Lead
-
02-26-2019, 05:41 PM #49
Doing it backwards -Max Purchase
I tried, and failed. Have tried to use the surf tab on one side to help but didn’t work. I don’t recall if I deployed the surf plate to 100....might try that just for kicks.
Also, I don’t plan on upgrading props, as I don’t think I’ll get that much lower of rpms and am happy with its performance. There are a couple of threads where folks seem to have found some better ACME props though.
Why the makai can do it with that much ballast....dunno...but guessing it has everything to do with auto launch that uses all three plates.
Sent from my iPhone using Tapatalk2018 Max - Ultrablue flake/Gray - 4400 lbs water (720s midship), 750 lbs lead somewhere
-
02-26-2019, 05:44 PM #50
What TXSurf says above is correct. I use to have to do that on my Supra SA with the 400 in it. When the boat was loaded down with full ballast and 800lbs of lead the boat would not get on plane without either dumping half of the ballast or switching to Wakeboard mode in the rider profiles. Once the boat got on plane I could reach down and switch off the rider profile and go about my way. I believe that is called the Auto Launch feature on Supra not sure what Moomba calls it now.
One thing that does work is having the 550 Raptor in my SL full ballast and 1000lbs of lead no problem right on plane.2018 Supra SL550 with 850lbs of lead wake
2017 Supra SA400 (Sold)
2016 Moomba Mojo Surf Edition (Sold)
2017 Ford F250 Super Duty (Sold)
2019 Ford F250 Super Duty (Sold)
2021 GMC Denali 2500
Soulcraft Vodoo
Soulcraft Jordi Pro
Soulcraft Super AV
Phase Five Matrix