Any ideas 2014 mondo trips ignition breaker

[samvq1]

It was not posted online. My boat is affected by the recall and my dealer sent it to me. I have not looked on the Moomba site to see if is posted.

Sent from my SGH-M919 using Tapatalk

[jstenger]

It was not posted online. My boat is affected by the recall and my dealer sent it to me. I have not looked on the Moomba site to see if is posted.

Sent from my SGH-M919 using Tapatalk

I checked the Moomba, Skiers Choice, and Dealer Connect websites. Nothing was posted yet.

[samvq1]

I hope it was ok I posted it. I didn't think about it not being a public release document.

Sent from my SGH-M919 using Tapatalk

[jstenger]

I hope it was ok I posted it. I didn't think about it not being a public release document.

Sent from my SGH-M919 using Tapatalk

Perfectly OK. This forum is our best source of info. I already called my dealer. I was only curious about the article because I wanted to see the pictures.

[spader]

I think my boat just succumbed to this tonight after around 18 hours on the engine. Temp was at 120, no speed. I was wondering what was going on and then the engine just cut out. I should have been reading this before because we got towed back to the boat ramp but I could have got the engine started again. Will have to call dealer tomorrow. My wires don't appear melted at the white plastic pigtail but the wire leading to the actual black plastic hull mount appears melted and there is a brown fluid around that melted wire. No fun.


Sent from my iPhone using Tapatalk

[Sampp1963]

Just got my new Mondo...serial number is C414....
Dealer is checking if my boat is in the list...
Does anyone knows if I have to put the boat out of the water to fix this?? My Mondo is always in the water and I have no truck...shit!!
And I guess I should unplug the pigtail in the meantime I get the new transducer??

[jstenger]

Just got my new Mondo...serial number is C414....
Dealer is checking if my boat is in the list...
Does anyone knows if I have to put the boat out of the water to fix this?? My Mondo is always in the water and I have no truck...shit!!
And I guess I should unplug the pigtail in the meantime I get the new transducer??

Boat has to be out of the water either on a lift or trailer. Transducer has a short pigtail, and is only held in by a simple plastic ring. Simple to replace.