Here’s what a lot of folks have expressed interest in - adding hinges to the bulky side bench seats on the max.

Keep in mind I am adding ballast under these seats so I don’t need access to the bottom of the compartment. If I was using it for storage I would use a different type of hinge so the seat goes up and back instead of forward and down.

Note: This is a temporary test run to see if they will work. I only put 2 screws in the seat bottom and used double sided sticky tape on the seat base. I’ll go back and add more screws to the seat and drill out the base and use machine screws with washers and nylon lock nuts when I have more time.







A link to the hinges:

https://www.greatlakesskipper.com/lu...SABEgIWwPD_BwE