upgrading LSV08 from Cruise to PerfectPass, a new life has started

[jixim]

I saved for a few months the money and ordered the PErfectPass Stargazer wakeboard a couple weeks ago.
Install was fairly easy. The hard part was to center the display/button unit in the dashboard, because the bolt that's supposed to go on the hole at the bottom of the display unit was too low. I had to cut a notch (see attached pic), and then I also added mounting tape at the back of the display unit where the steel plate goes to hold it and make sure it won't slide down.
Wiring was more than simple on the lsv08 because it's ready to go. The only glitch came from the harness... the Orange STATUS wire and the Black GROUND wire were reversed on this harness. It took me and the folks at PP a few days to discover this, but the first move from PP was to overnight a new system. Bad luck and really good support. One other small thing: there are 3 wires hanging on the harness, labeled "SWITCH", "TIMER" & "TIMER": don't worry about then, but the install guide forgot to mention it.
The good surprise: the PP displays the water temperature. I did not know there was also a sensor pre installed on the boat!

Finally, on the water it's night and day compared to the moomba cruise. Really that's not a spending, that's an investment. I love it!
JC