Packing Jam Nut Wrench...1-7/8

[mcdye]

I have a VDrive and wanted a wrench. Could not justify $25+shipping on some I had found. I tried the spanner wrench and channel locks but the area is SO tight. Finally ran across this ebay posting. I brought one and cut the other end off of it. It will work for the tight space to tighten the jam nut. In fact I brought 2 hoping to grind the opening a little bigger to hold the packing nut while tighten the jam nut. It is label as "light torque" but I think it will be fine for what I intend to use it for. It was a tough one to cut with a hacksaw...

http://cgi.ebay.com/ebaymotors/ws/eB...K%3AMEWAX%3AIT

[Ian Brantford]

Great post! I just had to pay my marine mechanic half an hour's labour for another quick adjustment.

Is the main packing nut a 2" one?

[mcdye]

Is the main packing nut a 2" one?

Not sure not alot of room to measure. Maybe a DD owner can chime in.

[JesseC]

I use this wrench from Sears. Works great on my 02 LSV which has hardly any room.

Sears item # 00977178000 Mfr.model # 3840

http://www.sears.com/shc/s/p_10153_12605_00977178000P


.

[mcdye]

I use this wrench from Sears. Works great on my 02 LSV which has hardly any room.

Sears item # 00977178000 Mfr.model # 3840

http://www.sears.com/shc/s/p_10153_12605_00977178000P


.

I brought a wrench similar to that from HDepot, but returned it. I dont have enough room on the port side due to the fresh intake to get much of a turn. On the starboard side my ballast pump is in the way.

Which side are you getting a good turn from?

[BensonWdby]

I have a 99 Mobius DD. I use a Medium sized pipe wrench on the packing nut and a channel locks on the jam nut. I just hate pulling the floor access all the time ...

[Northofthe49th]

I work in aviation so I got one of our tin basher's to cut two flat wrenches out 1/4" alum
just measure your two nuts LOL rough cut on a band saw then clean it up with a file
They are now in the boat