Results 1 to 2 of 2
  1. 07-09-2009, 08:41 AM #1
    danimal365's Avatar
    danimal365
    danimal365 is offline Member
    Join Date
    Jan 2008
    Location
    Holt MI
    Posts
    97

    Default depth cable routing

    I'm going to install a depth gauge in my new LSV but I'm not sure how to get the cable routed through the floor. Anyone done this?

    Thanks
    Dan
    2008 LSV
    Reply With Quote Reply With Quote
  2. 07-09-2009, 01:07 PM #2
    jester
    jester is offline Senior Member
    Join Date
    Jun 2008
    Location
    Eugene OR
    Posts
    1,786

    Default

    When my depth cable was run they ran it on the starboard side of the boat next too the haul. It went above the speakers and to the dash.
    2008 Outback V - Sold but never forgotten.
    “Do not wait; the time will never be “just right.” Start where you stand, and work with whatever tools you may have at your command, and better tools will be found as you go along." -Napoleon Hill
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules