Results 1 to 4 of 4
Thread: Motor mounts / Alignment
Threaded View
-
03-11-2004, 12:13 PM #1Junior Member
- Join Date
- Jan 2004
- Location
- Gridley, CA
- Posts
- 13
Motor mounts / Alignment
I recently got the boat back from the body shop after some major fiberglass work, and I had to replace the two front motor mounts and noticed that the back mounts were slightly bent, so the motor sits about an inch back farther than it should, therefore the front motor mounts mounting holes do not line up. My question is, after I replace the rear motor mounts, how do I adjust the front or back or both mounts to achieve factory alignment with the shaft and prop? Do I have to take it in to a mechanic? Please help, I'm really looking forward to finally getting on the water this summer.
color=red]I finally got the poor boat back from the body shop, and I must say, the back of the boat looks great. If you didn't see the pics of the wreck from "Skeg Problem" you should go check them out then email me if you want to see the finished product.[/color]
Email: [email protected]
**Wonder if you can use html in this forum...<a href="mailto:[email protected]">Email Me</a>**Jonathan And Andrea Smith
Similar Threads
-
Stress cracks around ski platform mounts
By TN_Boarder in forum Service & RepairReplies: 8Last Post: 05-18-2007, 09:18 AM -
Engine Mounts help???
By JesseC in forum Service & RepairReplies: 5Last Post: 05-16-2006, 08:50 PM -
Alignment was easy
By Catdog1 in forum Service & RepairReplies: 20Last Post: 07-27-2004, 09:01 PM -
strut alignment
By mmoody in forum Service & RepairReplies: 2Last Post: 04-21-2004, 11:43 PM -
Tower Camera Mounts
By SMUMATTMAN in forum General ChatReplies: 0Last Post: 02-08-2004, 09:58 PM