Results 11 to 20 of 36
Thread: Wish me luck - summerize
-
04-19-2009, 10:38 AM #11Senior Member
- Join Date
- Jun 2008
- Location
- DFW, TX
- Posts
- 230
-
04-19-2009, 10:45 AM #12Sled491 Guest
Making progress
No lake today, best I can hope for is a pull at the Cable park by the airport here in Orlando. My flight isn't until 4:30 so I'm good to go!
-
04-19-2009, 11:25 AM #13Senior Member
- Join Date
- Jun 2008
- Location
- DFW, TX
- Posts
- 230
Sweet.
Okay, can someone help me find where I screw in the plastic strainer? I, for the life of me, do not see where it goes. Also, do the two drain plugs go on the aft end of the motor below the transmission fill? I can feel a hole on either side but it doesn't seem like they want to screw in. I need to go get a telescoping mirror to take a look.
I have a Direct Drive. Well, I guess I'll do the impeller now while the experts confer and give me a recommendation.
-
04-19-2009, 01:46 PM #14Senior Member
- Join Date
- Jun 2008
- Location
- DFW, TX
- Posts
- 230
I got the impeller done. That was easy.
I also found the water strainer.
So, now if someone can post a pic or something showing me where the two brass drain plugs go, I'll be ready to fire her up (with the DIY Fake-a-lake, of course).
-
04-19-2009, 02:26 PM #15Member
- Join Date
- Apr 2009
- Location
- Raleigh, NC
- Posts
- 62
I have a V-drive, but I assume the drain plugs are in the same in the engine on a DD. If you look at the winterization pictures in the following post, you'll see where the port side plug is in the 6th picture (and water coming out of the hole in the 7th picture):
https://forum.moomba.com/showthread....ight=winterize
-
04-19-2009, 03:48 PM #16Senior Member
- Join Date
- Jun 2008
- Location
- DFW, TX
- Posts
- 230
-
04-19-2009, 04:30 PM #17Senior Member
- Join Date
- Jun 2008
- Location
- DFW, TX
- Posts
- 230
And, all done.
Now, I need to do a test with the Fake-a-lake and wash it. Thanks for everyone's input and help.
-
04-20-2009, 04:21 PM #18Senior Member
- Join Date
- Jun 2008
- Location
- DFW, TX
- Posts
- 230
One question on the fake-a-lake. There's two intakes under the boat. Do I use the aft or forward to run the engine? Or, does it matter? Thanks!
(Direct Drive)
-
04-20-2009, 07:02 PM #19Sled491 Guest
One is for the ballast and one is for the motor. It should be the one on the port side just infront of the strut. It will also be the one that feeds the strainer.
-
04-20-2009, 07:48 PM #20Senior Member
- Join Date
- Jun 2008
- Location
- DFW, TX
- Posts
- 230