Results 1 to 3 of 3
Thread: FAE Install
-
09-15-2008, 04:46 PM #1Senior Member
- Join Date
- Jan 2008
- Location
- Pensacola, FL
- Posts
- 1,585
FAE Install
I was the winner of the FAE system from the Moomba Jamboree. I have tried to document the install. Total time was probably around 4-5 hours. I did it over a few days.
The instructions are adequate for the install and only a few tools are needed. Larry at FAE, will respond to phone and emails quickly if you need help.
1. You will need to do a few measurements for the system in order for it to fit your boat.
2. System as it arrived in 2 boxes.
3. Flanges put into the exhaust ports.1997 MasterCraft 205
2008 Moomba Outback
1999 MasterCraft Sportstar OB
1992 MasterCraft 205
1999 Malibu Response LX
1987 Marlin Magnum Skier
-
09-15-2008, 04:49 PM #2Senior Member
- Join Date
- Jan 2008
- Location
- Pensacola, FL
- Posts
- 1,585
1. Install the FAE to check clearances.
2. Check Clearance with Wake plate up
3. Square tube, measure to fitLast edited by maxpower220; 09-15-2008 at 04:52 PM.
1997 MasterCraft 205
2008 Moomba Outback
1999 MasterCraft Sportstar OB
1992 MasterCraft 205
1999 Malibu Response LX
1987 Marlin Magnum Skier
-
09-15-2008, 04:51 PM #3Senior Member
- Join Date
- Jan 2008
- Location
- Pensacola, FL
- Posts
- 1,585
Drill and tap treads for your bolts
Install square tube bracket
Installed and attached.
Of course, each boat will be different, but this is a general overview. There are a few ways to mount the square tube bracket to your swim platform, this is the way I chose.Last edited by maxpower220; 09-15-2008 at 04:53 PM.
1997 MasterCraft 205
2008 Moomba Outback
1999 MasterCraft Sportstar OB
1992 MasterCraft 205
1999 Malibu Response LX
1987 Marlin Magnum Skier