Results 1 to 7 of 7
Thread: Flush Kit 08 Outback
-
06-25-2008, 08:19 PM #1Senior Member
- Join Date
- Jan 2008
- Location
- Pensacola, FL
- Posts
- 1,585
Flush Kit 08 Outback
I ordered and installed a flush kit from skidim (Helpful people there). The install took about 30-40 minutes with a few simple tools. DIY will allow you to mount it where you would like, but there are space constraints. I run my boat in 'brackish' water sometimes, so this is much easier than using a fak-a-lake. The kit was around $60 shipped, so it is cheaper than the factory option if you don't mind a little project.
-
06-27-2008, 12:01 AM #2
are you happy with that kit? which size did you buy? thanks
-
06-27-2008, 01:41 PM #3Senior Member
- Join Date
- Jan 2008
- Location
- Pensacola, FL
- Posts
- 1,585
I am very happy with the kit, it is much better than crawling under a wet boat to hook up the Fake-a-lake. 1.25" is the size kit. If you order at skidim.com, just talk to the guys there and tell them your boat and model,they seem to know what you need.
A sharp razor knife (cutting hose in 2 places), screw driver (for the clamps), and wire cutters (wire inside stock hose) are the tools that you need.
-
06-27-2008, 02:07 PM #4Senior Member
- Join Date
- Jun 2008
- Location
- Eugene OR
- Posts
- 1,786
-
06-27-2008, 02:35 PM #5
-
06-27-2008, 02:40 PM #6Senior Member
- Join Date
- Jun 2008
- Location
- Eugene OR
- Posts
- 1,786
Ahh ok I know what wires he is talking about now. For some reason I was thinking a pump wire or something like that.
-
06-27-2008, 08:50 PM #7Senior Member
- Join Date
- Jan 2008
- Location
- Pensacola, FL
- Posts
- 1,585