Results 1 to 2 of 2
Thread: Stereo Gurus --EQ Amp Question
-
04-29-2008, 08:52 PM #1
Stereo Gurus --EQ Amp Question
I just bought two Clarion APX490M Marine Amps.. The amplifier's input
range is 200mV to 6.0V for RCA inputs. The EQ I bought is a Clarion EQS746 (the one everyone reccomeds) though it has an RCA output of 7V. Am I gonna fry the amps should I get a different EQ?
-
04-29-2008, 09:09 PM #2
No, you will not damage the amps. 7 volts is the Max Output Voltage.
With this unit they recomend to set your source unit volume at instalation leave it, adjusting the system volume with the volume control on the EQ. Dialing in the EQ using the directions found here will keep you from hurting anything.
(Instructions are on page 7.)
Similar Threads
-
Stereo
By drewdwn in forum General ChatReplies: 2Last Post: 04-21-2008, 06:04 PM -
Stereo EQ Help
By Madtown Mobius in forum General ChatReplies: 10Last Post: 04-15-2008, 09:14 PM -
stereo system question
By rdc724 in forum General ChatReplies: 5Last Post: 04-12-2007, 09:20 PM -
stereo system question
By rdc724 in forum General ChatReplies: 0Last Post: 04-09-2007, 08:34 PM -
stereo
By bama3300 in forum General ChatReplies: 4Last Post: 05-24-2004, 02:06 PM