cab13367's 2006 Mobius LSV w/ improvements

[cab13367]

[cab13367]

Replaced unused light pole receptable with 12V plug

[cab13367]

[jester]

[QUOTE=cab13367;38452]Replaced unused light pole receptable with 12V plug
[QUOTE]

I like the 12V outlit. Did you rewire it so it is no longer off the NAV switch? Did you have to do any fiberglass work or where you able to snap it in? I also like the Stainless Steel Thru Hull Fittings.

[cab13367]

jester,

I did not rewire it and I need to as it trips the breaker once in a while. I use it to air up a big tube so after running for a while, it will sometimes trip.

In regards to the fiberglass work question, below is a link to the install:

https://forum.moomba.com/showthread.php?t=4035

Al

[jester]

Thanks for the how too. This might be a project when i am floting on the lake waiting for the wind to die down.

[tejansma]

How much work was it to change your gauges around. I'm not a huge fan of the placement of the wakeplate gauge and like what you did with it.

[newty]

Great ideas! Love the 12 power on the side. Its beyond me why they put the light plug there anyway!:\ Love the stainless through hull hull fittings. Evry ploace I've looked they are like $35 a peice. Where did you get them and how much.
Your boat looks great! We need to get out together sometime. You going to the Portland reunion? I'm going to try to get there for a little bit but I have a wedding @ 4pm.

[cab13367]

Great ideas! Love the 12 power on the side. Its beyond me why they put the light plug there anyway!:\ Love the stainless through hull hull fittings. Evry ploace I've looked they are like $35 a peice. Where did you get them and how much.
Your boat looks great! We need to get out together sometime. You going to the Portland reunion? I'm going to try to get there for a little bit but I have a wedding @ 4pm.

Newty,

Thanks. Got the SS fittings below on a tip from Razzman. I paid $37 including shipping for all 4 fittings.

http://cgi.ebay.com/ebaymotors/Set-o...spagenameZWDVW

Yeah, I am planning to make it to the Portland Reunion. Would love to meet up - I'd like to check out your boat as well.

Al

[cab13367]

How much work was it to change your gauges around. I'm not a huge fan of the placement of the wakeplate gauge and like what you did with it.

Wasn't much work at all. Below is a link to my original thread on this with more info.

Al

https://forum.moomba.com/showthread.php?t=3675