Results 11 to 14 of 14
Thread: Thinking about buying a Moomba!!
-
01-09-2008, 02:33 AM #11
I also have a 2001 Outback LS. I purchased it used in 2005 with around 150 hours on it. I've replaced the swim platform padding, and upgraded the cup holders with stainless steel. Boat has operated flawlessly.
-
01-09-2008, 11:01 AM #12Senior Member
- Join Date
- Aug 2007
- Location
- Nashville, TN
- Posts
- 257
VFR - what did you replace the swim platform
what did you replace the swim platform padding with? I was thinking of doing the same.
-
01-09-2008, 02:10 PM #13
I went with Hydro-Turf Molded Diamond 40" x 62" sheet, and added 3M self adhesive. Cost was about $100.
The sheet wasn't large enough to do the whole platform, so I had to section it in 3 pieces. I took measurements off of a new Moomba platform. The newer platform pads are in three sections.
I tried all kinds of ways to get the adhesive residue from the old padding off of the platform. I found that the easiest way was to use a heat gun with a plastic scraper. This will get 95% off, then use acetone with a soft cloth to remove the rest.
-
01-09-2008, 02:25 PM #14Senior Member
- Join Date
- Aug 2007
- Location
- Nashville, TN
- Posts
- 257
Thanks for the advice. It looks good. My outback ls looks just like yours, except I don't have the tower. Good looking boat!
Similar Threads
-
Thinking buying a moomba mobius lsv
By dav0743 in forum Sales & InformationReplies: 6Last Post: 07-26-2007, 09:18 AM -
thinking about buying a outback LSV
By alli12903 in forum General ChatReplies: 12Last Post: 08-25-2005, 10:35 AM -
things to look for when buying a used moomba
By djiali in forum Service & RepairReplies: 3Last Post: 06-28-2005, 10:25 AM -
things to look for when buying a used moomba
By in forum Service & RepairReplies: 0Last Post: 06-27-2005, 09:46 PM -
buying a used moomba
By in forum General ChatReplies: 0Last Post: 11-11-2002, 10:55 PM