Results 1 to 3 of 3
Thread: Plumbing outback LS ballast
08-31-2007, 12:40 AM #1
Plumbing outback LS ballast
Hello, sweet forum you guys got going here. I bought my first boat this summer, an '03 outback ls. It has the tank under the rear seat, however its not plumbed. I searched and found lots of info on v's and plumbing for 3 tanks, etc.
Does anyone have a pic of how this tank is plumbed on their boat? The tank has 3 threaded inputs, two on top and one on the bottom. Do you run an input pump on top, and a second output pump also on top?
Are you able to buy the switches from moomba so it looks clean?
Thanks for any help!
08-31-2007, 10:35 AM #2
Check out these guys..
Im making my own version based on their design for my LSV, but I bet they have something for you.Jim Hagen
2011 Moomba Mobius LSV - Exiled
2002 Moomba Mobius LSV - Sold
08-31-2007, 08:12 PM #3
I checked that out last night. I just went to the hard ware store and about a bunch of stuff so I'm going to see what I come up with.
By stuey in forum Wakeboarding | WakeskatingReplies: 5Last Post: 04-21-2008, 10:32 AM
By byronkoz in forum General ChatReplies: 2Last Post: 02-08-2008, 08:35 PM
By sickmobV in forum Wakeboarding | WakeskatingReplies: 1Last Post: 09-21-2006, 11:03 AM
By LSV04 in forum Service & RepairReplies: 1Last Post: 06-12-2006, 08:48 PM
By AL02REDMOBLSV in forum General ChatReplies: 0Last Post: 02-03-2006, 03:31 PM