Results 1 to 5 of 5
  1. #1
    Join Date
    Nov 2013
    Location
    Kansas City, MO
    Posts
    291

    Default 07 LSV Trim Tab indicator and actuator question

    Just completed an upgrade to a '22 MOJO (pretty pumped) and I'm fixing a few odds and ends on my 07 before selling. I finally tracked down the correct actuators on the wake plate from bennett and they're installed and working. However, I need wiring information on the gauge! I cut the wire several years ago when I installed the wrong actuators so I don't remember how they were wired.

    From the Guage to the transom, there is a wire with a bare wire, and two greens.
    The actuator has black and red.
    Behind the guage the bare is connected to common ground.

    I'm assuming one green to each of red and black to make a circuit and the bare wire is just for the guage up front?

    TIA!
    2022 Mojo

  2. #2
    Join Date
    Nov 2013
    Location
    Kansas City, MO
    Posts
    291

    Default

    Replying to myself! Ha! There was a ground in the actuator wires. I hooked ground to ground then each of the greens to red and black. That got the guage working, but not properly. Only get half the indicated range even though the actuators are fully actuating.
    2022 Mojo

  3. #3
    Join Date
    Nov 2013
    Location
    Kansas City, MO
    Posts
    291

    Default

    Can anyone out there still running this era of boat lend the assist? Would be helpful to see how the actuator is wired into the wires that run back to the gauge.
    2022 Mojo

  4. #4

    Default

    IMG_2829.jpgIMG_2828.jpg
    Thatís what the back of my gauge looks like. The large green wire with two small green wires connect to the green wires in the plug and the bare connects to a black that goes somewhere else.
    2007 LSV
    2315 Acme prop
    Gravity III + 3 Johnsons
    1100s in the rear, IBS upfront
    Stock bags under the seats
    HDPE Surf Platform

  5. #5
    Join Date
    Nov 2013
    Location
    Kansas City, MO
    Posts
    291

    Default

    Quote Originally Posted by Leebo View Post
    IMG_2829.jpgIMG_2828.jpg
    That’s what the back of my gauge looks like. The large green wire with two small green wires connect to the green wires in the plug and the bare connects to a black that goes somewhere else.
    Thanks, appreciate it!
    2022 Mojo

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •