I have found a potential hurdle in my board rack plan….

While the pin will drop in to hold the rack in that ‘middle’ position, it will not fully drop in and ‘lock’ in place without some additional modifications…




In the photo you can see on the upper portion where it has an additional slot that allows the pin to full drop…. I will examine further but I think the plan will require more machining to have it fully drop into place….

I may (at this point) cut my losses and move onto just installing the new board racks, finish up the engine panels (very necessary) and then jump into the new horn (Hornblasters Sniper) install…. Followed by the new flag pole holders and sunshade…. Yes, I know… I tend to always have a few projects on the go….


Sent from my iPad using Tapatalk