Page 4 of 5 FirstFirst ... 2345 LastLast
Results 31 to 40 of 44
  1. #31
    Join Date
    Aug 2021
    Posts
    17

    Default

    Everything arrived last week and is now installed in the boat.

  2. #32
    Join Date
    Apr 2013
    Location
    Knoxville TN
    Posts
    3,217

    Default

    When is your first test run?
    2018 Supra SL400

  3. #33
    Join Date
    Aug 2021
    Posts
    17

    Default

    Test run was this past Sunday. Fill and empty times are way less than the original system. It was roughly a 10-13 hour install. I guessed at which side of the pump is the intake and I guessed wrong. I'll flip the switches around and flip the rocker cover. I kept the 3/4" under the floor and tapped into that for ease of assembly. I was too busy to stop for photos, sorry. After the first try I fell in love with this system. I'm now building a portable ballast pump with the left-over parts to fill the original bags for the bow.

    While I'm messaging here, I do have a question on the boat. While I was pulling the kids knee boarding, I adjusted the trim, and when I did the engine stalled but started right back up on its own and the perfect pass shut off and came back on. It did this again when we were surfing, it wasn’t the trim tab I adjusted I went to empty the rear right ballast bag. As soon as the pump turned on it did it again. I always have the battery switched to #1 while I’m driving. I feel like maybe the house battery might be dying or is dead and whenever I put draw on the house battery by turning on a pump or moving the trim tab could it be pulling too much voltage from the engine battery and shutting the system down? Or is the voltage sensitive relay not working properly? Any thoughts on where I should start to diagnose an issue like this would be appreciated.

  4. #34

    Default

    A little more than 3 months later, my bags are supposedly going to ship tomorrow.
    2017 Moomba Helix

  5. #35
    Join Date
    Apr 2013
    Location
    Knoxville TN
    Posts
    3,217

    Default

    Quote Originally Posted by acj3 View Post
    Test run was this past Sunday. Fill and empty times are way less than the original system. It was roughly a 10-13 hour install. I guessed at which side of the pump is the intake and I guessed wrong. I'll flip the switches around and flip the rocker cover. I kept the 3/4" under the floor and tapped into that for ease of assembly. I was too busy to stop for photos, sorry. After the first try I fell in love with this system. I'm now building a portable ballast pump with the left-over parts to fill the original bags for the bow.

    While I'm messaging here, I do have a question on the boat. While I was pulling the kids knee boarding, I adjusted the trim, and when I did the engine stalled but started right back up on its own and the perfect pass shut off and came back on. It did this again when we were surfing, it wasn’t the trim tab I adjusted I went to empty the rear right ballast bag. As soon as the pump turned on it did it again. I always have the battery switched to #1 while I’m driving. I feel like maybe the house battery might be dying or is dead and whenever I put draw on the house battery by turning on a pump or moving the trim tab could it be pulling too much voltage from the engine battery and shutting the system down? Or is the voltage sensitive relay not working properly? Any thoughts on where I should start to diagnose an issue like this would be appreciated.
    Voltage issues will cause these boats to do quirky things. I'm pretty sure the owner's manual recommends running in 1&2 positions b/c of the number of electronics on these boats.
    2018 Supra SL400

  6. #36

    Default

    Bags finally made it!
    2017 Moomba Helix

  7. #37
    Join Date
    May 2020
    Location
    Steamboat Springs, CO
    Posts
    219

    Default

    Quote Originally Posted by spatty99 View Post
    Bags finally made it!
    awesome...you were probably as excited as I was!
    2022 MAX
    450 Raptor
    Steamboat,CO

  8. #38
    Join Date
    Feb 2018
    Location
    Boating on Lake Martin, AL
    Posts
    1,623

    Default

    Hopefully they’ve got through whatever hurdles have been slowing them down lately. Glad yall got your orders now.
    2024 Supra SV 400 “SUPA DUPA”
    2019 Moomba Max - sold"MOOMBAE"
    2016 Yamaha AR192 - sold

  9. #39
    Join Date
    Nov 2016
    Location
    Knoxville, TN
    Posts
    1,428

    Default

    Ordered some ballast impellers Monday, got them in in 4 days. Maybe it's just custom stuff or bags that's taking so long.
    2018 Supra SA400 aka The Ron Burgandy
    2011 Sea-Doo Wake 155
    2015 Mojo Surf, sold...2013 Axis A22 Recon Edition, sold...2010 Axis A22, sold...2007 Maxum 1800sr3, sold

  10. #40
    Join Date
    Apr 2013
    Location
    Knoxville TN
    Posts
    3,217

    Default

    Quote Originally Posted by KnoxMojo View Post
    Ordered some ballast impellers Monday, got them in in 4 days. Maybe it's just custom stuff or bags that's taking so long.
    How much are the greens ones now days - $40ea?

    I'm due to order them, but not looking forward to getting to the two pumps in the trans hatch area - those are more of a PITA.
    2018 Supra SL400

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •