Moomba Makai Owners- Adding Weight?

[TXSurf4]

I will just order 2 different buttons and see which one works. I won’t be back at the lake house until next weekend and I want to do it then. The one I really want to use has a depth of 1.30” as it is a flush mount and I think it will be too deep but we will see.


Sent from my iPhone using Tapatalk

[HFarr]

I will just order 2 different buttons and see which one works. I won’t be back at the lake house until next weekend and I want to do it then. The one I really want to use has a depth of 1.30” as it is a flush mount and I think it will be too deep but we will see.


Sent from my iPhone using Tapatalk

I misunderstood your clearance question. There is only one small area where the wires run through with enough room to put the switch. Unless you want to do some cutting....

Sent from my SM-G781V using Tapatalk

[HFarr]

Picture behind the light cover

Sent from my SM-G781V using Tapatalk

[TXSurf4]

Picture behind the light cover

Sent from my SM-G781V using Tapatalk

Ahhh that make sense. If you still have it off can you tell me the width of the opening?


Sent from my iPhone using Tapatalk

[TXSurf4]

Looking at the picture I realized you took this a while ago before you installed the switch lol no worries looks like maybe 1/2” wide


Sent from my iPhone using Tapatalk

[HFarr]

Yeah that was a long time ago. But you are probably right. Maybe slightly larger.

Sent from my SM-G781V using Tapatalk

[TXSurf4]

Yeah that was a long time ago. But you are probably right. Maybe slightly larger.

Sent from my SM-G781V using Tapatalk

We will be this back on topic lol so did you get the new bags installed and tested out?


Sent from my iPhone using Tapatalk

[HFarr]

Ok. So I installed one of the wakemakers upgrade bags for the Makai this evening. Had to reinforce my side panels, so I have not upgraded the starboard side yet. These new bags have a strange shape I must admit. I thought they would just be taller, but you can see from the pictures with air in them that the ends are shaped differently too.

Sent from my SM-G781V using Tapatalk

[HFarr]

Here are some pictures of the new bag, Port, compared to the stock bag, Starboard. I only filled it one time and drained them. Not sure if it just needs sliding around a bit or what, but it didn't want to sit against the back wall of the boat where the fill & drain lines are. The shape doesn't really seem to fit the space exactly for something that was designed too. Maybe it needs adjusting in the space a bit, but not a lot of room for movement with the hoses at each end connected up. It also interferes with the tray about 2". Which is really a bummer. I can see where it could have been designed to get the same volume and work with the trays too. My fill sensor is also at the top of its limit unless I pop it off the hard tube and strap it to the flexible hose. I just run my pumps till the overflow comes out the side of the boat. Also burp all the air out just at or before 90%.

Sent from my SM-G781V using Tapatalk

[HFarr]

Some pictures of the 1/2" channel to reinforce the side panels, which would pop out even with stock bags all the time. Also the tray sitting on top of the wakemakers bag.

Sent from my SM-G781V using Tapatalk