Results 101 to 110 of 127
-
07-30-2022, 10:51 AM #101
I did this yesterday, and yep it was just that simple. Can't believe I didn't catch that before. I should have snapped a quick picture, but both bags filled out the entire space and went way up near the top. I still have not done anything to fix my rear panel that popped out of the track on me as I showed earlier. At least my sides seem to be holding well now. Hope I didn't just jinx myself!
Sent from my SM-G781V using Tapatalk2021 Moomba Makai
Black Cherry Metal Flake & Fire Red
Nibral OJ 15.5x15 Altitude/Wake prop w/1.76 trans v-drive
Wet Sounds bow speakers & 10's on the Tower & ported sub
-
07-30-2022, 11:53 AM #102Junior Member
- Join Date
- Jun 2021
- Posts
- 16
Could you put a piece of 1” aluminum angle iron under the original channel to keep the panel from pushing in. That is what I am going to try on my side panels
-
07-30-2022, 06:32 PM #103
I will probably end up putting a longer and deeper piece of channel there. You can see in the picture that the existing one does not go all the way to the end of the carpeted panel. On the sides, I would still recommend putting some metal on them to stiffen them. Then put some small screws in the bottom to keep from pulling out. They are soft and bow quite a bit.
Sent from my SM-G781V using Tapatalk2021 Moomba Makai
Black Cherry Metal Flake & Fire Red
Nibral OJ 15.5x15 Altitude/Wake prop w/1.76 trans v-drive
Wet Sounds bow speakers & 10's on the Tower & ported sub
-
07-30-2022, 06:37 PM #104
Here are couple of pictures of my left and right rear bags filled now that I made sure they were centered and were not folded up on themselves as they were filling. I unscrewed one of the vent caps as they started to Balloon up and let all the air escape. That's 100% water in those pictures.
Sent from my SM-G781V using Tapatalk2021 Moomba Makai
Black Cherry Metal Flake & Fire Red
Nibral OJ 15.5x15 Altitude/Wake prop w/1.76 trans v-drive
Wet Sounds bow speakers & 10's on the Tower & ported sub
-
07-31-2022, 05:28 AM #105Senior Member
- Join Date
- Mar 2022
- Location
- Winston Salem NC
- Posts
- 155
Double post
Last edited by dyrmz134; 07-31-2022 at 05:41 AM.
2022 Makai 400
15.5x16.5 prop (18 back up)
Chilltech
Premium Wetsounds Package
WakeMakers (custom) bag upgrade
-
07-31-2022, 05:29 AM #106Senior Member
- Join Date
- Mar 2022
- Location
- Winston Salem NC
- Posts
- 155
2022 Makai 400
15.5x16.5 prop (18 back up)
Chilltech
Premium Wetsounds Package
WakeMakers (custom) bag upgrade
-
07-31-2022, 10:13 AM #107
Speaking of storage bins...I posted some pictures early on with my storage bins sitting on top of the WM bags full, or what I thought was full, and they only sat a few inches higher than the fiberglass around the locker. I will have to do that again as I am sure they would be drastically higher now.
Sent from my SM-G781V using Tapatalk2021 Moomba Makai
Black Cherry Metal Flake & Fire Red
Nibral OJ 15.5x15 Altitude/Wake prop w/1.76 trans v-drive
Wet Sounds bow speakers & 10's on the Tower & ported sub
-
08-01-2022, 08:16 AM #108
[QUOTE=dyrmz134;381041]No, unfortunately our lake is now 4' down and I had to pull the Makai off the lift and put it in the garage so that it didn't get stuck on the lift. Our last trip up I didn't pull it out as we just played on the Jet Skis and surfed on our neighbor's Malibu as he is still able to get his boat on and off his lift (at least for the next few weekends). It seems like some others have gotten it figured out here in the post below though. Our next trip up I am going to launch the boat and just anchor it up in front of our boat house for the weekend so I will definitely try it out and report back.
2019 Makai
Raptor 450 w/ 1.76 Trans
WakeMakers 1350s in the rear & 1K in Lead
-
08-09-2022, 10:36 PM #1092020 Moomba Mojo
2008 Mastercraft Prostar 197 40th Anniversary
Owner Ness Lake Watersports
Wakemakers “Exact Fit” Bags + Lead = 4,700 ballast
Audio by Wetsounds, MTX, JL Audio, Clarion
15 X 13.00 ACME prop
-
08-12-2022, 09:59 PM #110