Replacing center ballast

[3threecs]

Currently troubleshooting my 2018 Craz G3, center ballast pump. Last year it seemed to work intermittent, and was relatively loud, yesterday it didn't work at all.

I checked the breakers, they are good. I will check the fuses this afternoon, I believe they are on the port side behind the wall of the back locker.

Any tips for replacing the pump if it comes to needing it? Can it be replaced through the access hole or does the fuel tank have to be removed.

Thanks

CG

[Zog]

Isn't the pump in the back wall of the locker? That's where mine are. The center pump on mine sits in the starboard locker behind the panel.

[3threecs]

On the g3, I have one under subfloor between gas tank and ballast tank

[Holdmybeer]

The G6 has one under the floor.
G3 they are all behind the rear locker panels.

If G6, you have to pull the floor. Could be a bad impeller amd the motor/pump is spinning fine.

[3threecs]

The pump is the problem, I took one off the back and plugged it in and it works fine.

I pulled the impeller on the center pump and the shaft is hard to turn.

I really don’t see a way to unmount the pump and hose all from the access port. Any ideas?

CG

[jnr4817]

My 2018 Mojo has center pump located between center ballast tank and fuel tank under floor. Starboard and poet pimps are located behind back locked walls.

I’d be able to remove thru port hole but removing floor would
Make it way easier.