I just bought 2 new kicker KMS67 tower speakers to replace older blown out current speakers. I will keep the same pods

The speakers are rated at 4 ohms 200 RMS

My amplifier is 4 chanels x 100watt RMS at 4 ohms. Bridged it is 320 watt RMS at 4 ohms.

Two chanels are used to power the inside speakers. I have a separate amp for the subwoofer.

How should I wire the two speakers to the amp?

I am thinking about bridge the amp and wire the speakers in series that will give me a total impedance of 8 ohms. The minimum impedance required by the amp if bridge is 4ohms. Therefore I could not wire the speakers in parallel because that would give me just 2 ohms.

I could also not bridge the amp and use one chanel per speakers. That would give me 100watt RMS at 4ohms. But the speakers are rated at 200 watts at 4ohms is this enought?

so, in your opinion, bridge or no bridge??????

or new amp…………