2015 Mojo Plate removal

[SorryCharlie]

I'd remove the 5200 square area and then get some looking stainless round head bolts and use 5200 to seal them.

That stuff is a PIA to try and remove. I don’t think it’s 5200, the spray doesn’t work on it. It’s some kind of thick padding that’s glued tight.

[cucv]

What are you getting for a retracted angle? Did you move the actuator just because of the wire location? You can use a remote gland for the wire if you need it in a different location.

Sent from my SM-G991U using Tapatalk

[HFarr]

Rob says you just have to deploy both tabs for “launch” mode. Seems pretty easy.

The water is not in the bilge, it’s in the sub floor under the bag compartment, I’m not sure if there is a path from the bilge though? The bilge around the engine compartment looks sealed up to me. The bilge in the engine compartment is dry.

I would think there would be a path somewhere from the ballast compartment to the bilge pump. There has to be. Otherwise a leaking bag could really cause some bad problems.

Sent from my SM-G781V using Tapatalk

[SorryCharlie]

I would think there would be a path somewhere from the ballast compartment to the bilge pump. There has to be. Otherwise a leaking bag could really cause some bad problems.

Sent from my SM-G781V using Tapatalk

A leaking bag dumps into the engine bilge, ask me how I know 😂

[SorryCharlie]

I have the holes filled, I used the West Epoxy kit and the wires are ready to hook up. Getting that 502 off is a nightmare, it helped some getting an oscillating multi tool. That removed a fairly thick layer of 502. The rear is not perfect yet, I still have some more work to do there but with temp in the mid 80s, I have to test it out.

[SorryCharlie]

I would think there would be a path somewhere from the ballast compartment to the bilge pump. There has to be. Otherwise a leaking bag could really cause some bad problems.

Sent from my SM-G781V using Tapatalk

2 of the holes seeped all week, they are below the bag floor and there is no access to that area. I’m guessing there is somewhere for the water to go. If the bag leaks, it goes into the engine bilge but I’m talking about below the black floor that the bags sit on. Wish I knew if there is an outlet for water there.

[Holdmybeer]

Watched several install videos online of surf plate systems on Malibu boots and the lowest hinge holes all weeped also. Looks like it's not just Moomba.

[Teamwieland]

2 of the holes seeped all week, they are below the bag floor and there is no access to that area. I’m guessing there is somewhere for the water to go. If the bag leaks, it goes into the engine bilge but I’m talking about below the black floor that the bags sit on. Wish I knew if there is an outlet for water there.

Were you able to get the Evolution Tabs installed and try them out?

[odvagnulixr]

if you pull it back there is a chance of damage.

[MJHSupra]

When surfing, does the one tab fully re-track into a position to not interfere with the wave?

I have seen tab systems where the tab, in the fully up position, interfere with the wave causing the lip to get 'washy' or you have something that looks like a 'line' going into the wave from the transom to the back of the wave.