Results 31 to 35 of 35
Thread: Heater installation 2020 Mojo
-
09-23-2021, 04:10 PM #31Senior Member
- Join Date
- Jul 2021
- Posts
- 107
Unfortunately I’m not gonna be at the boat for a couple of days and I did forget to take pictures. However my auxiliary pump is installed on the feed side of the heater coil. This means that it pushes water into the coil. Unlike water pump which needs to be on the return side from heat exchanger.
As for the Wiring, there is a plug on the V drive side of the block with the label heater only.
I had to take that apart and use the male female connectors and pins one and two. If you test it with the meter you will see that even with the ignition on and the engine not running there’s no voltage but as soon as engine is running there is 14 V DC on pins one and two.
Sent from my iPhone using Tapatalk
-
09-23-2021, 07:17 PM #32
Makes sense. Thanks!! I would definitely like to see your hose connections to the pump whenever you get a chance. I’m thinking about picking one up too.
Sent from my iPhone using Tapatalk
-
10-05-2021, 10:42 PM #33
Any updates on pics brother?
Sent from my iPhone using Tapatalk
-
10-10-2021, 10:04 PM #34Senior Member
- Join Date
- Jul 2021
- Posts
- 107
I’m sorry that it has taken me this long to get to it but I finally remember to make a video showing hose connection and routing. So here it’s is.
https://youtu.be/N2iHvhYtApI
Sent from my iPhone using Tapatalk
-
10-10-2021, 11:01 PM #35
This is awesome thanks so much!!!
Sent from my iPhone using Tapatalk